Installation Manual - Unical Lattner Condensing Hot Water Boilers

Instructions for the installer3.2 - CODE AND STANDARDSAPPROVALSALKON 50 - 70 has been reviewed for compliance with theapplicable sections of the following NorthAmerican Standards:ANSI Z21.13 / CSA 4.9 - Gas-fired low pressuresteam and hot water boilersASME SECTION IV: ASME Boiler and Pressure VesselCode with addenda, Section IV: Rules for Construction ofHeating BoilersSCAQMD RULE 1146.2. EMISSIONS OF OXIDES OFNITROGEN FROM LARGE WATER HEATERS AND SMALLBOILERS AND PROCESS HEATERSCSD-1: CONTROLS AND SAFETY DEVICES FORAUTOMATICALLY FIRED BOILERS3.3 - PACKAGINGThe ALKON 50/70 boiler is supplied fully assembled in astrong cardboard box.After having unpacked the boiler check that it isintact and undamaged.CAUTIONKeep the packaging material (cardboard box,plastic bags, polyester protection etc.) out ofthe reach of children as they can bedangerous.LATTNER refuses all liability for injury topersons, animals or damage to propertyderiving from not having respected the abovementioned recommendations.In the packaging, in addition to the boiler, you can also findthe following contents:- Tecnical documetation set- N° 3 plastic plugs for fixing boiler Ø 0,47‘‘ (12 mm)- Boiler support bracket- Condensate evacuation siphon- Aluminum pipe Ø 3.1‘‘ (80 mm) for smoke evacuation- Thread Adapter Kit NPT/gas (Supply - Return - Gas),with sealing rings.- Gas Ball Valve 3/4”14.6’’(370 mm)28.1’’(715 mm)40.4’’(1025 mm)CAUTIONThe boiler may be damaged when not securedproperly.- Only transport the boiler using appropriate transportationequipment, such as a handtruck with a fastening belt orspecial equipment for maneuvering steps.- When shipping the boiler must be secured on the transportationequipment to prevent it from falling off.- Protect all parts against impacts if they are to be transported.- Follow the transportation markings on the packaging.• Packaged boilers must always be lifted and carried by twopeople, or you must use a handtruck or special equipmentfor transport.14