Dishwasher Training/Repair Manual

10/ /Part # 3 – Apexx Control ModulesDisassemblyApexx (SHV99A/SHX99A-B/SHY99A, DWHD94) control modules aredifferent than other models and are removed differently. Modules aremounted on the base (where base wiring connectors were), not behindfascia panels. This means:• Dishwashers must be pulled out to change control modules.• Dishwashers must be pulled out to measure voltages &resistances./These instructions apply toSHE/SHV/SHX98-99 models.HINT: Apexx controlmodules cannot bechecked or haveresistances measuredfrom the front ofdishwashers.For access to Apexx control modules:Tools needed: T-20 Torx screwdriver & pliers.1. Remove outer door – see page 3.2. Remove toe kick – see page 4.3. Remove right/left side panels – see page 4.4. Raise right side of tank – see page 5.NOTE: Modules weremoved to the base to makeroom for the larger full textdisplays in the fascia panel.HINT: Its helpful, but notnecessary, to remove outerdoors to access Apexxcontrol modules.HINT: It may be possible to reachbehind modules without blockingup tanks. If not, then follow theseinstructions to block up tanks.702_58300000133621_ara_en_aRev 0 (1/17/08)