70-6676 Getting Started- CoulArray® Data Station V3 - VTP UP

Chapter 4There are two ways to set the cell potentials:Figure 4-2: The Cell Setup Dialoga) Enter the desired value in each field.b) Use the Increment Potentials group of controls in the upper right corner.In most cases, the cell potentials are set at a fixed increment (e.g., cells 1 through 4 might beset to -100, -60, -20 and +20 mV, respectively). The Increment Potentials fields in the upperright corner could be used to set this series of potentials using the following entries:Start with Cell: 1Start Potential: -100Last Cell: 4Increment: 40After the desired values have been entered, click Increment. The potential for each cell inthe range will be set in the appropriate field. If desired, you can also edit each channel on anindividual basis. To set the potential for cell 10 to 250 mV, move the cursor to that field,34 CoulArray ® Data Station 3.00Getting Started Manual