ST-7000-C SERIES - toshiba tec europe

1. OUTLINE OF THE SYSTEM EO10-12027(revision Date: Mar. 16, 2007)1.4 Basic Specifications(19) Interface on the RISER PC BoardThe following I/O ports on the RISER PC board are expandable.• POWER LED, HDD LED, POWER SW, RESET SW, BUZZER volume• HDD interface (IDE Interface Primary/Secondary), HDD/CD-ROM power• ATX PS interface• PCI interface• USB interface• 12-24V Step-Up (Boost) DC-DC converter• Printer power connector (24V)• IO board interface• Wake On LAN• PS/2 keyboard (not available)• FAN connector(20) Watchdog Timer FunctionTogether with BIOS and OEM drivers, the Watchdog Timer function is activated, which prevents a hang atthe time of OS start-up. The Watchdog Timer is a circuit for monitoring the microcomputer’s performanceand the system condition and for inquiring the system performance. When detecting some fault condition,an interrupt signal is immediately sent to the CPU and a system restart is performed, resulting in that thesystem returns from the hung state into normal operation.1.4.1.2 POS Functions(1) Drawer interfaceA maximum of two drawers containing the TOSHIBA TEC standard 24V drive circuit can be connected.• 4-pin modular type x 2• 4-pin type x 1(Not used, Japan model only: when the option KIT-7000-PUSB-QM is installed.)Connector specifications4-pin modular typeDrawer Connector Type PC Board RemarksDrive circuit contained on the drawer4-pin modular Engine boardsideDrawer 1Not used, Japan model only4-pin typeIO board4-pinDrive circuit not contained on the(Option)drawer sideDrive circuit contained on the drawerDrawer 2 4-pin modular Engine boardside(2) Serial interfaceCOM1 and COM2COM3 to COM6COM1, COM2: 9-pin DSUB (male) as standardCOM3, COM4: 9-pin DSUB (female) as standard. +5V and +12V can be supplied.COM5, COM6: 9-pin DSUB (female) (option) +5V and +12V can be supplied.COM5 is provided on the I/O PC board, and COM6 is provided on the I/O PC board orthe 10-pin box connector is provided on the RISER PC board. When using COM6, theoption KIT-7000-COM-QM is required.COM3 to COM6 do not have the RI and DCD signals.(3) Powered USB (Installed on the I/O board): optionFour Powered USB ports equipped with 12V/24V power supply can be used. These ports are provided onthe I/O PC board.• Number of ports supported12V P-USB x 3, 24V P-USB x 1 (KIT-7000-PUSB-QM)24V P-USB x 1 (KIT-7000-2COM-QM)1-12