Vantage 2210 / 2200 IOM - Eastech Flow Controls

02) Program Continued04) 4-20 Out>1) Up 2) Down. . . . . . . . . . . . . . . . .>3) Coarse 4) Fine>5) 4 mA 6) 20 mA4-20 Output Assignment and AdjustmentSelection 4 in the programming menu is the 4-20mA output and assignmentadjustment. Press the 04 key to adjust or assign the 4-20mADC output.1) Adjustment: To adjust or calibrate the 4-20mA DC output press the 01key. For the Vantage 2220 another screen will prompt to select whichsensor 4-20 output to adjust.To adjust Zero: Press the 5 key, the cursor arrow will appear before the 5) 4mA line. Press the 3 key for coarse adjustment or the 4 key for fine adjustment.Now press the 1 key to adjust the mA upwards or the 2 key to adjustdownwards.To adjust Span: Press the 6 key, the cursor arrow will appear before the 6) 20mA line. Press the 3 key for coarse adjustment or the 4 key for fine adjustment.Now press the 1 key to adjust the mA upwards or the 2 key to adjustdownwards.To assign the 4-20mA loop the level or flow press the 02 key at the 4-20 Outselection. To select the 4-20 signal to track level press the 01 key. To selectthe 4-20 signal to track flow press the 2 key. Press the ENTER key. If twosensors are being used, added assignments for Flow 2, Level 2, Flow 1 + 2and Flow 1 – 2 will be available.Programming Setpoints05) Setpoints This selection will allow the user to assign up to three setpoints for High orLow alarm conditions. Press the 05 keys to enter the setpoint selections. Pressthe 01 keys for Setpoint #1. Press the 02 keys for Setpoint #2. Press the 03keys for Setpoint #3. The next screen allows the user to assign the setpointselected to level or flow. Press the 01 keys for Level and the 02 keys forFlow. The level selection will be in the engineering units selected for level.The flow selection will be in engineering units selected for flow. The nextscreen will allow the user to input ON and OFF points for the setpointselected. For Low alarm the ON value will be less than the OFF value. ForHigh alarm the ON value will be greater than the OFF value. To programmove the cursor to the left most significant digit by using the DOWN/LEFTarrow key. Enter the number desired by using the keypad. The cursor willadvance to the right after the selection is entered. Press the ENTER key. TheSetpoints must be assigned to a Relay. (14 keys under Program.).Sensor Calibration>06) Sensor Cal. To adjust the sensor calibration, press the 06 keys. The dimension physicallymeasured from the bottom the sensor to any target or liquid level is thedistance that will be displayed in the next screen. If the dimensions displayedvary from the distance measured, use the 1 or 3 key to adjust the displayedlength to the measured length.Vantage 2200 3-6