Vantage 2210 / 2200 IOM - Eastech Flow Controls

More documents

Recommendations

Info

FB31" NPTFB3 Sensor Dimensions:3.25"5.50"The FB3 sensor is used for applications where themaximum level is 50 feet. (See Specifications Page1-2.) There is a 1 inch NPT threaded nipple on topof the sensor for mounting on bracket or customerprovided flange.4.00"VMt mTVerticalMountingDimensionOffsetSpanZeroOffsetSpanMinimumFB2 – 12"FB3 – 24"Sensor Mounting Terms:Whether the sensor is to be used for flow inconjunction with a primary element such as flumesor weirs, or used for level measurement only, thereare two terms that must be understood to mount thesensor properly in either application.1. The VMt is the vertical mounting distancebetween zero level (zero flow level of flumes orweirs or zero level of tank) and the bottom of thesensor. This is the offset plus the span.Consideration must be given when mounting thesensor in respect to sidewalls. The distance from awall to the FB2 sensor is 0.875 inch per foot of VMt.For the FB3 it is 1.5 inches per foot of VMt.2. The HMt is utilized in flow applications. It is theupstream horizontal distance that the sensor needs tobe placed from a reference point of the primaryelement. The HMt dimension is displayed on the2200 when programming the unit. Refer to Page 3-12 for mounting detail for various primary elements.Vantage 2200 2-3
Wiring DiagramThere are three terminal strips provided for all wiring of the Vantage 2200. The AC power terminal isseparate from the other two terminal strips. The power terminal strip has three connections for High,Low and Ground for AC voltage only. Refer to the wiring diagram below for all internal wiringconnections. The specifications for the load requirements for each input are on Page 1-2Specifications. The unit may also be powered with 12 VDC at TBA Terminals 18 (+) and 19 (-).All of the terminal connections for the output signals are depicted in the above drawing. The wiringconnections are also on the inside of the enclosure terminal access cover.If the unit is supplied with the modem option, the telephone connection is made on the Relay #5 NOand NC terminals as shown below.Telephone connectionsfor modemVantage 2200 2-4
Page 3 and 4: General DescriptionThe following de
Page 5: 5.00"4.00"2.75".38"1.88"3.00".38"Se
Page 9 and 10: Vantage 2200 Splice ProcedureWhen a
Page 11 and 12: 2) ProgramProgramming for Level/Vol
Page 13 and 14: 2) Program Continued>02)Weirs 01) V
Page 15 and 16: 02) Program Continued04) 4-20 Out>1
Page 17 and 18: 02) Program Continued11) Pump Alt.T
Page 19 and 20: 05 System Setup>05) System SetupThe
Page 21: Sensor Vertical and Horizontal Moun
Page 24 and 25: WEIRSSideViewTop ViewH MtZeroV MtWe
Page 26 and 27: Vantage 2200 Parts ListPART NUMBERD

Vantage 2210 / 2200 IOM - Eastech Flow Controls

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?