Panamera

Screw in one assembly aid on vehicles without PCCB
8. Screw in assembly aids instead of wheel bolts.
Caution!
Risk of damage to brake discs.
f Always screw in the assembly aids when
changing a wheel.
292 Minor Repairs
Screw in two assembly aids on vehicles with PCCB
9. Remove the remaining wheel bolts.
10.Take the wheel off and put a new wheel on.
f Please see the chapter “WHEEL BOLTS” on
page 293.
11.Insert wheel bolts and tighten by hand.
12.Remove assembly aids and screw in remaining
wheel bolts.
Initially tighten bolts only slightly in
diagonally opposite sequence so that
the wheel is centerd.
13.Inflate the tire if necessary.
f Please see the chapter “TIRE PRESSURE FOR
COLD TIRES (68 °F/20 °C)” on page 326.
14.Lower the vehicle fully and remove the jack.
15.Tighten wheel bolts in diagonally
opposite sequence.
Immediately after changing a wheel, use
a torque wrench to check the prescribed
tightening torque of the wheel bolts
(160 Nm/118 ftlb.).
Note on operation for vehicles with Tire
Pressure Monitoring
f On vehicles with Tire Pressure Monitoring, the
settings on the multi-function display must be
updated after the wheel change.
f Please see the chapter “TIRE PRESSURE
MONITORING (TPM)” on page 127.