Dangerous Power G3 Spec R Manual - Mcarterbrown.com

REMOVING TRIGGER FROM FRAME1. Locate the two trigger adjustment screws. Use (5/64”) allen key wrench to loosen and remove both screws byturning them counterclockwise. Be careful not to misplace the screws. (SEE PIC A . B)2. Locate trigger removal screw. Use (3/32”) allen key wrench to loosen and remove screw by turning itcounterclockwise. Carefully pull out screw. Note that the latter part of the screw is a bolt, which the triggerhinges upon. (SEE PIC C . D)3. Remove trigger assembly by lifting it up and out of G3 Spec-R trigger frame. (SEE PIC E)RAPS FLIP LEVER ASAREMOVAL AND MAINTENANCEThe RAPS TM ASA was designed to be virtually maintenance free. However, it may be necessary to occasionallyclean and inspect for debris or damage, as either may cause malfunction or leaking of air.1. Remove macro-line from RAPS TM ASA. (SEE PIC A)2. Remove butterfly grip panels from trigger frame. (SEE PIC B)3. Disconnect solenoid wiring harness from circuit board. (SEE PIC C)4. Locate the three screws securing circuit board to trigger frame and unscrew using a crosshead (Phillips)screwdriver. Carefully remove the circuit board from the trigger frame. (SEE PIC D)AB C DEAB C D42 W W W . D A N G E R O U S P O W E R . C O M43