5700 WOOD STOVE - Hearth & Home Technologies

R5700 ACT Wood StovePEDESTAL OR LEG KIT INSTALLATIONWARNING: DO NOT OPERATE STOVE BEFORE FULLY ASSEMBLING ALLCOMPONENTS. BURNING YOUR STOVE WITHOUT A PEDESTAL OR LEGKIT ATTACHED WILL VOID YOUR WARRANTY AND COULD PRESENT ASAFETY HAZARD.PEDESTAL MODEL1 Place protective pad or stove pallet on floor.2. Lay body of stove on its back on protective pad orpallet.3. Loosen screws on adapter and slide pedestal overadapter on bottom of stove4. Line up holes in sides of pedestal with holes inadapter.5. Securely tighten pedestal into place.6. Carefully stand stove up and place in desired location.7. Slip wooden decorative strips onto pedestal edges.8. Open door of stove and check to make sure firebricksand ceramic blanket are in their proper locations (seepages 23-24). FIGURE 16ALEG MODEL1. Remove leg mounting brackets packaged inside firebox.2. Place protective pad or stove pallet on floor.3. Lay body of stove on its back on protective pad orpallet.4 Remove the bolts, using a 9/16” Hex Head socket orwrench, from the adapter and save.5. Secure mounting brackets to the bottom of the stovewith 1/4”-20 Phillips screws. See Figure 16A. Thesescrews are located on the outer skin at the bottom rearof the stove.6. Loosely assembly bolts into the corner of the mountingbrackets.7. Slide legs onto mounting brackets and tighten.8. Carefully stand stove up and place in desired location.9. Use leveling bolts on legs to stabilize and level stove.10. Open door of stove and check to make sure firebricksand ceramic blanket are in their proper locations (seepages 23-24).FIGURE 16BLeg MOUNTINg brACKeTS(packaged inside stove firebox).CAUTION! DO NOT TILT THE UNIT ON THECAST IRON LEGS. Lift the unit upright andplace it into position on the floor protector.Page 16250-7090ESeptember 1, 2008