Wadkin ECA Tenoner Manual and Parts List

HONEHONEGROUND CUTTERFIG. 5___""'11FIG. 6SHAPED HONESHAPEDCUTTERHONING.Cutters must have a razor sharp cutting edgebefore commencing to cut. To obtain thisedge it is necessary to hone the cutters usinga 142 carborundum slip stone. This will ensurea good finish on the wood and an easyfeed.Dull cutters give a poor, rough andplucked out finish and make it difficultthe job past the cutters. Honingby a reciprocating or rotary motion on thecutter, using a little paraffin to give !the stone. The honing stone is a muchgrit than the grindwheel and leaves awww.wadkin.comkeen edge. A number of honing stonesdifferent shapes, e. g. round or square sticksinfo@wadkin.comwill be found helpful in honing shapedrs,