Wadkin ECA Tenoner Manual and Parts List

TENON BLOCK ADZE CUTTER GRINDING ATTACHMENT (Continued)Take an initial roughing cut of one or one-and-a-half thousandths of an inch on one knife, turnthe block round to the next knife and take the same cut, proceeding thus until both knives havebeen ground. After grinding completely round the block, take successive light roughing cutsuntil both knives are sharpened. On the roughing cuts use a rapid table traverse. On the finishingpass, reduce the cut to one-half thousandth of an inch and use a slow table traverse to ensurea keen cutting edge and uniform blade height.Finally check the setting of the knives on the tenon block setting stand.FIG. 29. Showing the tenon blocks set up forgrinding.www.wadkin.cominfo@wadkin.comFIG. 30. Showing the actual operation of grinding,indicating the best position for the operator.Page 26