Installation Operation Maintenance

More documents

Recommendations

Info

ControlsThermostats6 thermostats are available:THS01/THP01, THS02/THP02 andTHS03/THP03."THS" are non programmablethermostats, "THP" areprogrammable.01 and 02 series are conventionalthermostat, 03 series are dedicatedto the controller.Table 42 - Thermostat featuresTHS01 THP01 THS02 THP02 THS03 THP03non-programmable X - X - X -programmable - X - X - Xelectronic X X X X X Xunit control type design electromech. electromech. electromech. electromech. Reliatel Reliatelinterface card needed - - - - - -for Cooling Only units X X - - X Xfor Heat Pump units - - X X X Xfor Gas Fired units X X - - X XCooling stages 2 2 2 2 2 2auxiliary heating stages(elec. heater, HWC )heating stages(heat pump mode)2 2 1 1 2 2none none 1 1 1 1liquid crystal display X X X X - XNote: thermostats are powered up by the rooftop control (24V)42RT-SVX20B-E4
ControlsOther accessories availableRemote temperature sensor to beused with THS/THP 01-02.TZS01: Remote room temperaturesensor to be used with THS/THP 03,Tracker or Varitrac systems.DTS: Duct temperature sensor to beused with THS/THP 03.TZS02: Remote room temperaturesensor with adjustable thumwheelsetpoint to be used with Tracker orVaritrac systems.TZS04: Room temperature sensorwith adjustable thumbwheel andoverride button, to be used withTracker or Varitrac systems.Refer to separate documentation formore information.Communication InterfacesTRANE Communication Interface(TCI-R) boardThis is an electronic board, factorymountedin the main control panel,needed to allow communicationbetween a TRANE IntegratedComfort system (TRACKER orVaritrac CCP2) and the unit. (COM3-COM4)LON Communication Interface(LCI-R) boardThis is an electronic board, factorymountedin the main control panel,needed to allow communication ona LonTalk ® Network at the unit level.LonTalk ® Communication Interface(LCI-R) board allows Voyager unitsto communicate on a LonTalk ®Network at the unit level. Networkvariables are based on theLonMark ® . Space Comfort ControllerFunctional Profile Template. TheLCIV uses a Free Topologytransceiver FTT-10A. The FTT-10Atransceiver supports non-polaritysensitive, free topology wiring,allowing the system installer to usestar, bus, and loop architecture. TheLCI-V can also be connected to anoptional High Temperature LimitSwitch if installed with the rooftopunit. For more information, seeattached manual LTCI-IN-1.RT-SVX20B-E443
Page 1: InstallationOperationMaintenanceVoy
Page 7 and 8: InstallationDimensions/Weights/Clea
Page 9 and 10: InstallationInstalling the unitDisc
Page 11 and 12: InstallationTable 4 - Duct dimensio
Page 13 and 14: InstallationGas pipework installati
Page 15 and 16: InstallationTo increase airflowLoos
Page 17 and 18: InstallationSupply fan performances
Page 19 and 20: InstallationTable 14 - TSD 090 Avai
Page 21: InstallationTable 18 - TSD 120 Avai
Page 24 and 25: InstallationTable 24 - YSD 090 Avai
Page 26 and 27: InstallationTable 28 - YSD 120 Avai
Page 28 and 29: InstallationTable 32 - WSD 072 Avai
Page 30 and 31: InstallationElectrical connectionTh
Page 32 and 33: InstallationTable 37 - Compressor a
Page 34 and 35: ControlsTrane THS01,THS02, THP01 an
Page 36 and 37: ControlsWiring the wall-mounted CO2
Page 38 and 39: ControlsMounting the duct-mounted C
Page 40 and 41: ControlsFire thermostatThere are tw
Page 44 and 45: Unit OptionsHot water coilIn order
Page 46 and 47: Unit Options0 - 50% fresh air hoodT
Page 48 and 49: OperationOperation with aconvention
Page 50 and 51: OperationUnoccupied modeIf the ther
Page 52 and 53: OperationTest proceduresOperating c
Page 54 and 55: OperationUnit start-upVerification
Page 56 and 57: OperationReliaTel is a microelectro
Page 58 and 59: OperationEconomizer Set-UpAdjusting
Page 60 and 61: MaintenanceTo keep the unit operati
Page 62 and 63: MaintenanceTroubleshootingThe RTRM
Page 64 and 65: MaintenanceService FailureMeasure t
Page 66 and 67: MaintenanceTo Test Humidity Sensors
Page 68: www.trane.comFor more information,

Installation Operation Maintenance

Create successful ePaper yourself

Delete template?

Save as template?