Polyethylene Water/Sewer - JM Eagle

More documents

Recommendations

Info

Revised March 2011JME-11B© J-M Manufacturing Co., Inc.Building essentialsfor a better tomorrowGLOBAL HEADQUARTERS:Nine Peach Tree Hill RoadLivingston, NJ 07039T: 973.535.1633F: 973.533.4185www.JMEagle.comREGIONAL OFFICE:5200 West Century BlvdLos Angeles, CA 90045T: 800.621.4404F: 800.451.4170
Page 1 and 2: HIGH-DENSITyPOLYETHYLENEWATER/sewer
Page 8 and 9: Publications by the American Societ
Page 10 and 11: or together with internal pressure
Page 12 and 13: 3.2.1 Unloading Site RequirementsTh
Page 14 and 15: 3.4 DraggingOccasionally, when long
Page 16 and 17: 3.9 Pipe Placement in TrenchesJM Ea
Page 18 and 19: 4.0 TESTING4.1 Leak TestingThe inte
Page 20 and 21: Other pressure testing procedures m
Page 22 and 23: • The piping system is so designe
Page 24 and 25: ENGINEER.5.1 Damage AssessmentDamag
Page 26 and 27: 5.2 Heating Tool MaintenanceClean h
Page 28 and 29: Table 3Pipe SizeSocket Fusion Time
Page 30 and 31: 6.2 Butt Fusion: Reference PPI’s
Page 32 and 33: perature-measuring device should be
Page 34 and 35: Visually mitered (angled, off-set)
Page 36 and 37: Heat Soak Force—The force (pounds
Page 38 and 39: surized or non-pressurized main.6.2
Page 40 and 41: Figure DCorrectly Made Socket Fusio
Page 42 and 43: Caution: To assure flow control, ye
Page 44 and 45: Notes:

Polyethylene Water/Sewer - JM Eagle

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?