ASR-10 Operator's Manual - MPCStorageSolution

Section 1 — Controls and Architecture8) Pedal•CVThis jack is for connecting an optional ENSONIQ Model CVP-1 Control Voltage Foot Pedal,which is assignable as a modulator to various parameters within the ASR-10. The pedal givesyou a handy alternative modulation source when, for example, you would want to use the ModWheel but both hands are busy.ENSONIQCVP-1Control Voltage Foot PedalA CV pedal plugged into this jack can also act as a Volume pedal, controlling the volume of thecurrently selected Instrument•Sequence Track(s). A parameter on the Edit/System•MIDI page(press Edit, then System•MIDI, then scroll until the display reads PEDAL=VOLUME MIDI=7),determines whether the CV pedal will act as a modulator or as a volume pedal. Set toPEDAL=VOLUME to use the CV pedal to control volume.Pedal/CV Specs: 3-conductor (Tip= control voltage input, Ring=510 ohm resistor to +5 Volts,Sleeve= ground). 36 KOhm input impedance, DC coupled. Input voltage range=0 to 3 volts DC.Scan rate=32mS (maximum recommended modulation input= 15 Hz). For use with an externalcontrol voltage, use a 2-conductor cable with the voltage on the tip and the sleeve grounded.Rear Panel Connections 3