ASR-10 Operator's Manual - MPCStorageSolution

Section 1 — Controls and Architecture14) Audio Input — B/Right and A/LeftThese jacks are the Right and Left Audio Inputs into the ASR-10 for sampling or Audio Trackmonitoring of external analog audio sources.SPECS: 140 KOhm input impedance, AC coupled. The Audio Inputs have 2 ranges: Line andMic. With the Mic/Line switch set to Line, theASR-10 will accommodate signals from +15.5dBV (Input Level Trim control fullycounterclockwise) to -16.5dBV (Input Level Trim control fully clockwise). With the Mic/Lineswitch set to Mic, the ASR-10 will accommodate signals from -11.5dBV (Input Level Trim controlfully counterclockwise) to -43.5dBV (Input Level Trim control fully clockwise). Matching theappropriate input level with the correct settings of the Mic/Line switch and Input Level Trimcontrol will bring the external signal source up to clipping level.15) Main Out — Right/Mono and Left/MonoTo operate the ASR-10 in stereo, connect these outputs to two discrete channels of your mixerand pan the mixer channels right and left. Note that either of the audio outputs can be used as amono output. If you want to listen to the output in mono, make sure that only one of the outputjacks is connected.16) PhonesTo listen to the ASR-10 in stereo through headphones, plug the phones into this jack. The phonesoutput contains a mix of the signal from the main outputs. Headphone volume is controlled bythe volume slider on the front panel. Note that plugging headphones into this jack does notautomatically turn off the audio in the right and left outputs.Rear Panel Connections 5