MiniSteam Instruction Manual - HygroMatik

More documents

Recommendations

Info

The steam cylinder consists of a top (16) and lower (19) partjoined with a cylinder flange. The seal between the cylinder andcylinder base (37), as well as between the top and lower part ofthe cylinder, is maintained using an o-ring (35).Warning:During operation and also soon afterwards the steamnozzle is hot! If touched this can cause burns to theskin.During operation the cross-flow fan rotates. Do nottouch the fan during operation.During operation hot steam discharges from the nozzle.In the field of the visible steam cloud contact can causeburns to the skin.Due to pollution or incorrect installation hot water coulddischarge from the nozzle.Page 14
5. InstallationWarning: Installation of this unit to be attempted only by qualifiedpersonnel. We accept no liability for damage due to faultyinstallation.Obey all safety notes and warnings present on the unit.During installation the unit must be disconnected from its powersupply.Attaching or installing additional components is permitted onlywith the written consent of the manufacturer, or else the warrantyis void.5.1 Steam Humidifier Operating EnvironmentNote: When selecting the installation site for the steam humidifier,note that: Ambient temperature must be between 5° and 40° C. Relative humidity must not exceed 80% RH. The minimum clearances indicated in the diagrambelow must be observed; these are necessary toensure adequate ventilation for the housing. The rear panel of the steam humidifier heats up duringoperation (to a maximum of 60°C). Take care that theconstruction on which the unit is mounted is not madeof temperature-sensitive material. Place the steam humidifier so that the unit is easilyaccessible with sufficient space to perform maintenance. Make sure that there are no people and bearing materialsbelow the steam cloud (approx. 3 meters in exhaustdirection). The steam humidifier is not qualified for exterior applications.Page 15
Page 1 and 2: ManualElectrode Steam HumidifierMin
Page 3 and 4: 1. Introduction ...................
Page 5 and 6: 1. IntroductionDear Customer,Thank
Page 7 and 8: 2. Safety Notes2.1 OverviewThese sa
Page 9 and 10: 3. Transport3.1 OverviewNote: Proce
Page 11 and 12: 4. Operation and Installation4.1 Mo
Page 13: The concentration of dissolved salt
Page 17 and 18: Wall MountingNote: The steam humidi
Page 19 and 20: 6. Water InstallationWarning: When
Page 21 and 22: » Use a cap nut (internal thread
Page 23 and 24: 7. Electrical ConnectionDanger, Haz
Page 25 and 26: MiniSteam:Type Power Usage Circuit
Page 27 and 28: 8. MaintenanceThe HygroMatik steam
Page 29 and 30: » The basic PCB (C) is now accessa
Page 31 and 32: » then:CleaningWarning: Check the
Page 33 and 34: » Push in safety fuses.Switch on t
Page 35 and 36: » Remove cylinder, as described in
Page 37 and 38: » Place solenoid valve with seal i
Page 39 and 40: 10. EC-Declaration of ConformityPag
Page 41 and 42: * MS5 MS10 Article no. DescriptionW
Page 43 and 44: 13. Technical DataTechnical Data St
Page 45 and 46: 15. View of housingPage 45

MiniSteam Instruction Manual - HygroMatik

Create successful ePaper yourself

Delete template?

Save as template?