MiniSteam Instruction Manual - HygroMatik

More documents

Recommendations

Info

8.4.2 Uneven Electrode LengthsIn most case, the longer electrode(s) will not be supplied withelectricity for a time. Therefore they will not wear. The cause ofthe problem, such as a tripped circuit breaker, can be repaired.However, since the shorter electrode(s) have a greater specificload, the electrodes continue to wear unevenly.Note: Replace electrodes with significantly uneven wear. Checkthe power supply (breaker, voltage drop). Also see electronicoperation, Section "Malfunctions."8.5 Replacing ElectrodesPage 34
» Remove cylinder, as described in Chapter 8.3 "Removingand Cleaning Steam Cylinder."» Loosen knurled nuts (5) and remove electrodes (48).» Install new electrodes and hand tighten the nuts.» Use solvent-free, <strong>HygroMatik</strong>-quality o-rings (for flange,cylinder base and steam hose adapter).» assemble steam cylinder and place it into housing.» Connect plugs (4) directly to the electrodes (48) (withgray, red and black knurled nuts). It is not necessary todetach the knurled nuts!Warning: The plug must be pressed down onto the electrode asfar as it will go.Note: Connect plugs to the correct electrodes. Pay attention tothe color of the knurled nut.» Attach plug (8) to the sensor electrode. < (Knurled nut(9) - gray)» Switch breaker back on.» Switch on the unit and check for leaks after 15-30 minutesof operation.If leakage occurs, switch off power supply and follow safetyinstructions for work on live components.Note:In the following cases: the electrodes must be frequently replaced, black slime collects inside the cylinder, or there is "lightning" in the cylinder,the conductivity of the water is too high or it isn't decanted oftenenough. In this case please contact <strong>HygroMatik</strong>.Page 35
Page 1 and 2: ManualElectrode Steam HumidifierMin
Page 3 and 4: 1. Introduction ...................
Page 5 and 6: 1. IntroductionDear Customer,Thank
Page 7 and 8: 2. Safety Notes2.1 OverviewThese sa
Page 9 and 10: 3. Transport3.1 OverviewNote: Proce
Page 11 and 12: 4. Operation and Installation4.1 Mo
Page 13 and 14: The concentration of dissolved salt
Page 15 and 16: 5. InstallationWarning: Installatio
Page 17 and 18: Wall MountingNote: The steam humidi
Page 19 and 20: 6. Water InstallationWarning: When
Page 21 and 22: » Use a cap nut (internal thread
Page 23 and 24: 7. Electrical ConnectionDanger, Haz
Page 25 and 26: MiniSteam:Type Power Usage Circuit
Page 27 and 28: 8. MaintenanceThe HygroMatik steam
Page 29 and 30: » The basic PCB (C) is now accessa
Page 31 and 32: » then:CleaningWarning: Check the
Page 33: » Push in safety fuses.Switch on t
Page 37 and 38: » Place solenoid valve with seal i
Page 39 and 40: 10. EC-Declaration of ConformityPag
Page 41 and 42: * MS5 MS10 Article no. DescriptionW
Page 43 and 44: 13. Technical DataTechnical Data St
Page 45 and 46: 15. View of housingPage 45

MiniSteam Instruction Manual - HygroMatik

Create successful ePaper yourself

Delete template?

Save as template?