MiniSteam Instruction Manual - HygroMatik

8.3 Removing and Cleaning the Steam CylinderWarning: Please follow the detailed instructions in these operatinginstructions! The unit is only to be serviced by qualified,authorized personnel. Note the warnings and safety notes in theoperating instructions. Failure to observe warnings and safetynotes may result in injury, serious injury or death, and/or damageto the unit. The steam cylinder may still be hot when youbegin maintenance work. Handle carefully!Warning: Both the clamps that fix the steam cylinder halves andthe electrodes have sharp edges and angles that possibly couldlead to cut injuries.Disassembly» Switch on the unit by the main switch. The humidifierruns the pump for a few seconds. The purpose of this isto check that the system is operating properly.» Drain residual water in the cylinder.» Units with Basic, Comfort or Comfort Plus control electronics:» Press the on/off control swith in position „II“.» Units with Comfort or Comfort Plus control electronics:» Press the Softwarekeys and simultaneouslylonger than 5 seconds.» Open and remove cover.» Disconnect the steam generator from the power supply.Control switch OFF and remove safety fuse F1.» Check that unit is without power.» Unscrew and remove the steam nozzle (1).» Unplug the electrodes (4).» Unplug the sensor electrode (10).» Remove adapter (2) between steam cylinder and steamnozzle (1).Page 30