MiniSteam Instruction Manual - HygroMatik

More documents

Recommendations

Info

Reassembly» Connect plug (10) to level sensor.» Connect plugs (4) to electrodes.»Warning: The plug must be pressed down onto the electrode asfar as it will go.Note: Connect plugs to the correct electrodes. Note the color ofthe knurled nut.Note: Condensate connection must be showing in the front onthe left.Page 32
» Push in safety fuses.Switch on the unit and check for leaks after 15-30 minutes ofoperation.If leakage occurs, switch off power supply and follow safetyinstructions for work on live components.8.4 Electrode wearElectrode wear depends on:feed water composition and conductivity.the quantity of steam produced.Warning: At the latest, electrodes must be replaced if a maintenancemessage is displayed. The maintenance messageappears after one hour of operation at maximum water level.The humidifier switches itself off. Also see Section "Maintenance."When the electrodes are less than 1/3 to 1/2 of theiroriginal length, replace them.8.4.1 Original Electrode LengthsOriginal lengths of <strong>HygroMatik</strong> large area stainless-steel electrodesare:HyLine:Type HY05-HY08 HY13-HY60 HY90-HY116Length[mm]155 235 300CompactLine:Type C6 C10 C17-45 C58Length [mm] 125 155 235 300<strong>MiniSteam</strong>:Type MS5 MS10Length [mm] 125 155Page 33
Page 1 and 2: ManualElectrode Steam HumidifierMin
Page 3 and 4: 1. Introduction ...................
Page 5 and 6: 1. IntroductionDear Customer,Thank
Page 7 and 8: 2. Safety Notes2.1 OverviewThese sa
Page 9 and 10: 3. Transport3.1 OverviewNote: Proce
Page 11 and 12: 4. Operation and Installation4.1 Mo
Page 13 and 14: The concentration of dissolved salt
Page 15 and 16: 5. InstallationWarning: Installatio
Page 17 and 18: Wall MountingNote: The steam humidi
Page 19 and 20: 6. Water InstallationWarning: When
Page 21 and 22: » Use a cap nut (internal thread
Page 23 and 24: 7. Electrical ConnectionDanger, Haz
Page 25 and 26: MiniSteam:Type Power Usage Circuit
Page 27 and 28: 8. MaintenanceThe HygroMatik steam
Page 29 and 30: » The basic PCB (C) is now accessa
Page 31: » then:CleaningWarning: Check the
Page 35 and 36: » Remove cylinder, as described in
Page 37 and 38: » Place solenoid valve with seal i
Page 39 and 40: 10. EC-Declaration of ConformityPag
Page 41 and 42: * MS5 MS10 Article no. DescriptionW
Page 43 and 44: 13. Technical DataTechnical Data St
Page 45 and 46: 15. View of housingPage 45

MiniSteam Instruction Manual - HygroMatik

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?