Griffon 2000TDX Hovercraft - HovercraftModels.com

Recommendations

Info

Griffon 2000TDX 1/30 th Scale Radio Controlled HovercraftHovercraftmodels.comCutting out the Passenger Cabin CoverThis cover is cut so that fits between the engine cover and cabin on theupper deck.Cutting out the Rudder Support StructureThe rudder support structure is cut and then folded from the long strip molding. Cut out the entire stripfrom its molding and fold down the two sides carefully away from the top bar.Rudder support cut out and preparedDO NOT score the fold lines with a knife blade as the plastic willsimply break apart. It will help to warm the fold lines slightly with ahairdryer or model aircraft cover shrinking hot airgun first. Slowlyand carefully fold the sides down so that they are at 90º to the topbar of the structure. Now fold the tabs at the bottom of the sidepieces inwards at 90º to complete the rudder support shaping.Support top bar with side bentdown ready for assemblyAssembly of the Rudder SupportNow cut out the ‘T’ shaped base of the rudder support. The curved sides of the molding should be left inplace all around the piece to add strength except on the base and each end of the ‘T’. This needs to becut flat so it can be fitted onto the upper deck and glued tothe rest of the assembly. Drill a 1/16 th inch hole wheremarked by a small dimple in the piece.The center rudder support must now be cut out. Removethe molded edges so that it makes a flat part.Start assembly by gluing the tabs at the base of the sidesof the support, under either side of the ‘T’ base. Use smallclamps to hold it in place while setting. Glue the centersupport into the assembly using the groove in the baseand the line in the top of the rudder support as a guide for location. The rudder support is now complete.6
Griffon 2000TDX 1/30 th Scale Radio Controlled HovercraftHovercraftmodels.comAssembly and Installation the Rudder and Thrust DuctBend down90 degreesGlue Duct HereBend down90 degreesRudderCenterSupportRudderUpperSupportThrust DuctLeft RudderSupportRudderBase 'T'SupportRight RudderSupport'T' SupportRetaining Screw( Requires 5/64thhex key)RudderSupport andThrust DuctRear ViewBend down90 degreesBend down90 degreesGlue Tabs HereUpper DeckRudderSupportAssemblyThrust DuctPropellerRightHandRudderRudderBase 'T'SupportMotor MountGray ClipThrustMotorThrustMotorWiresRudderSupport andThrust DuctSide ViewRudderHornEngineCover'T' SupportRetaining Screw(Option to glue herewhere duct touchesengine cover)Upper DeckNote: Drawing is not to scale7
Page 1 and 2: Radio ControlledGriffon 2000TDXHove
Page 3 and 4: Griffon 2000TDX 1/30 th Scale Radio
Page 5: Griffon 2000TDX 1/30 th Scale Radio

Griffon 2000TDX Hovercraft - HovercraftModels.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?