ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch
ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch
ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
g) Height of cylinder has to be 87 mm -0,05/+0,1 mm (measured with a digitalcaliper min. length 200mm).h) Cylinder surface:All transfer ports and passages have cast finish surface except someremoval (done by the manufacturer) of cast burr at the inlet passage,exhaust port and passages. All ports have <strong>ch</strong>amfered edges to preventring snagging. Any additional ma<strong>ch</strong>ining is not permitted.The top edge of exhaust port may show some pre-existing ma<strong>ch</strong>ining fromthe manufacturer. The sealing flange for the exhaust socket may showsigns of ma<strong>ch</strong>ining from the manufacturer.TYPICAICTUREAll ports have <strong>ch</strong>amfered edges.Any additional ma<strong>ch</strong>ining is not permitted.On cylinders marked 223 993 and 223 994 the upper edge of the centralboost port may show factory ma<strong>ch</strong>ining.TYPICAL PICTUREpage 10 of 53 RMC/RMCGF <strong>Te<strong>ch</strong>nical</strong> Regulations 2013/Bul.1 Edition: 10.01.2013
Change language