ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch

More documents

Recommendations

Info

f) Height of cylinder has to be 86,7 mm -0,05/+0,1 mm (measured with adigital caliper min. length 200mm).g) Cylinder surface:All transfer ports and passages have cast finish surface except someremoval (done by the manufacturer) of cast burr at the inlet passage andexhaust port and passages. All ports have chamfered edges to preventring snagging. Any additional machining is not permitted. The top edge ofexhaust port may show some pre-existing machining from themanufacturer. The sealing flange for the exhaust socket may show signsof machining from the manufacturer.YPICALpage 32 of 53 RMC/RMCGF Technical Regulations 2013/Bul.1 Edition: 10.01.2013
All ports have chamfered edges.Any additional machining is not permitted.On cylinders marked 613 933 the upper edge of the central boost port mayshow factory machining.TYPICAL PICTUREThe sealing flange for the exhaust socket may show either cast finishsurface or signs of machining from the manufacturer.The top edge of the exhaust port may show either just a cast finishsurface…page 33 of 53 RMC/RMCGF Technical Regulations 2013/Bul.1 Edition: 10.01.2013
Page 1: APPROVEDROTAX MOJO MAX ChallengeTec
Page 4 and 5: 7) Safety of equipment:For RMCGF an
Page 6 and 7: The ROTAX authorized Distributor or
Page 8 and 9: ABNOTE: This check is just for refe
Page 10 and 11: g) Height of cylinder has to be 87
Page 12 and 13: The exhaust port may show partial m
Page 14 and 15: d) Crankshaft main bearing 6206 fro
Page 16 and 17: e) The ignition coil has to be fixe
Page 19: • Outer diameter of clutch drumDi
Page 22 and 23: • Top bore diameter 2,60 +/- 0,15
Page 24 and 25: • Angular bore: Plug gauge 0,60 m
Page 26 and 27: • Atomizer, diameter of cross bor
Page 28 and 29: Version 39.2.9) Radiator coolant:As
Page 30 and 31: 9.3) Technical Specification (withi
Page 34: or signs of a CNC machining …or s
Page 37 and 38: 9.4) Technical Specification (outsi
Page 39 and 40: 9.4.3) Balance drive:a) Balance dri
Page 41 and 42: • Inner diameter of clutch drumTh
Page 43 and 44: 9.4.7) Intake silcener:a) Intake si
Page 45 and 46: • Top bore diameter 2,60 +/- 0,15
Page 47 and 48: PICTUR• Angular bore: Plug gauge
Page 49 and 50: • The two vent fittings must be c
Page 51 and 52: d) Diameter of hole of end cap of (
Page 53: page 53 of 53 RMC/RMCGF Technical R

ROTAX MOJO MAX Challenge Technical ... - Rotaxmax.ch

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?