This manual must be read thoroughly and always - esco ...

Product Manual escostart DS3 49
4G – Frequency Check
4H – Frequency Variation
8.1.5 Protection Delays
5A – Restart Delay
5B – Current Imbalance Delay
5C – Undercurrent Delay
Range: Do Not Check
Start Only
Start/Run (Default)
Run Only
Description: Determines when and if the starter will
monitor for a frequency trip.
Range: ± 2 Hz
± 5 Hz (Default)
± 10 Hz
± 15 Hz
5D – Instantaneous Overcurrent Delay
5E – Input A Trip Delay
Description: Selects the soft starter's tolerance for
frequency variation.
Range: 00:01 - 60:00 (minutes:seconds) Default: 10
seconds
Description: The escostart DS3 can be configured to
force a delay between the end of a stop and the beginning of the next start.
During the restart delay period, the display shows the time remaining before
another start can be attempted.
Range: 0:00 - 4:00 (minutes:seconds) Default: 3 seconds
Description: Slows the escostart DS3 response to
current imbalance, avoiding trips due to momentary fluctuations.
Range: 0:00 - 4:00 (minutes:seconds) Default: 5 seconds
Description: Slows the escostart DS3 response to
undercurrent, avoiding trips due to momentary fluctuations.
Range: 0:00 - 1:00 (minutes:seconds) Default: 0 seconds
Description: Slows the escostart DS3 response to
overcurrent, avoiding trips due to momentary overcurrent events.
Range: 0:00 - 4:00 (minutes:seconds) Default: 0 seconds
Description: Sets a delay between the input activating
and the soft starter tripping.
Product Manual escostart DS3 49