Download - All Fasteners

8: DRILLING & CUTTING8E.090 890 Series Raised Panel Bit Carbide Tipped + Ball Bearing GuideWe offer you the traditional approach to panel construction with the CMT raised panel bit. Make classic raised paneldoors as shown in the profiles below. The raised panel bits have carbide tipped cutting edges and are equipped with ouranti-kickback design and orange non-stick coating to further increase your safety when working with larger diameter bits.ORDER CODECutting Overall Diameter/Minimum Board ThicknessMatch ProfileDiagramSHANKSIZE$/EACH8CMT-890-501-11 82.5 (3-1/4”)/15mm A 1/2”8CMT-890-502-11 82.5 (3-1/4”)/15mm B 1/2”8CMT-890-503-11 82.5 (3-1/4”)/15mm C 1/2”8CMT-890-504-11 89.0 (3-1/2”)/18mm A2 1/2”8CMT-890-505-11 89.0 (3-1/2”)/18mm B2 1/2”8CMT-890-506-11 89.0 (3-1/2”)/18mm C2 1/2”8CMT-890-507-11 89.0 (3-1/2”)/15mm D2 1/2”Profile D2 image notavailable - contact oursales team for moreinformation8E.091 890 Series Vertical Raised Panel Bit Carbide TippedMill raised panel doors and drawer fronts easily and economically by putting a CMT vertical raised panel bit inyour router* and a sturdy 90° fence on your router table. *Recommended for use on routers of minimum 2-1/4hp.Routers as low powered as 1-1/2hp can be used but we suggest limiting their use to shorter, shallower runs.ORDER CODECutting Overall Diameter/X cutter lengthMatch ProfileDiagramSHANKSIZE$/EACH8CMT-890-601-11 38.0 (1-1/2”) x 35mm A 1/2”8CMT-890-602-11 38.0 (1-1/2”) x 35mm B 1/2”8CMT-890-603-11 38.0 (1-1/2”) x 35mm C 1/2”8E.092 890 Series Raised Panel Bit Carbide Tipped + Back Cutting BladeThe 89mm diameter bit has a back cutter which allows milling of both the front and back of the panel in thesame cut. An additional 32mm bearing promotes safety by allowing you to take two shallow passes.ORDER CODE Cutting Overall Diameter Profile SHANK SIZE $/EACH8CMT-890-524-11 89.0mm Ogee 1/2”8CMT-890-527-11 89.0mm Cove 1/2”8.078MELBOURNE03 9330 0555SYDNEY1300 255 327© 2011 ALLFASTENERS