2000 Series Articulator and QuickMount Face-Bow ... - Whip Mix

More documents

Recommendations

Info

Transfer Of Casts To Another ArticulatorIt is often desirable to remove the casts from the Whip Mix Articulator on which they wereoriginally mounted and to place them on another Whip Mix instrument. This is a greatconvenience when the casts are to be forwarded to an out-of-town laboratory.The only change from the customary procedure for mounting is the method of mountingthe mandibular cast. The “split-cast” mounting technique using notches is followed, OR,the cast is attached to its mounting plate so that it can be easily removed later withoutdanger of damage.The following are sent to the laboratory:• The mounted maxillary cast• The mandibular cast (removed from its mounting)• A duplicate patient registration card• The interocclusal centric registration used in the original mounting• The plastic incisal guide table on which the incisalguidance has been recordedThe technician places the mounted maxillary cast on the articulator. Using the centricregistration, the mandibular cast is then mounted to the lower frame of the secondarticulator. The incisal guide table is positioned, and the incisal pin is adjusted to thecorrect vertical height. The condylar guidance is set from the notations on the patient’srecord card, and the transfer is complete.If the “split technique” was used on the first mounting of the mandibular cast, this originalmounting should be saved. When the casts are returned, they can be quickly replacedon the original articulator.50
Interchangeability With The Model 2240And 2340 ArticulatorThe Model 2240 and 2340 Articulators incorporate the basic design of the Model 2200 andare modified with the “ACCUMOUNT” Mounting System. The “ACCUMOUNT” System makesit possible for the dental practitioner and the dental laboratory to interchange casts withoutexchanging articulators.Features and Advantages1. When clinicians and dental students use a dental laboratory that has a Model 2240 or 2340Articulator, casts need no longer be mounted on an articulator when shipped to sucha laboratory.2. Clinicians can purchase fewer instruments while maintaining the same levelof care for their patients.3. Instrument damage caused by shipping the articulator to and from the dental lab is eliminated.4. Precise alignment of the upper and lower frames is checked at the factory prior to shipping.51
Page 1 and 2: 2000 SeriesArticulatorandQuickMount
Page 3 and 4: CONTENTSINTRODUCTION 5OBTAINING FAC
Page 5 and 6: INTRODUCTIONThe WHIP MIX Articulato
Page 7 and 8: Fig. 5Loosen the #8604 thumb screw
Page 9 and 10: III. Positioning Face-Bow on the Pa
Page 11 and 12: Fig. 21To prevent torquing of the f
Page 13 and 14: Centric Relation RecordFig. 27Many
Page 15 and 16: Lateral Interocclusal RecordsFig. 3
Page 17 and 18: Fig. 41Loosen the #8511 incisal gui
Page 19 and 20: II. Placing a Direct Mounting Face-
Page 21 and 22: Fig. 57Engage the centric latch for
Page 23 and 24: INDIRECT MOUNTING THE MAXILLARY CAS
Page 25 and 26: Fig. 72Raise the face-bow fork supp
Page 27 and 28: Fig 80If using the Model 2340 Artic
Page 29 and 30: Fig. 87Prepare a second mix to fill
Page 31 and 32: Fig. 93If using the Model 2340 Arti
Page 33 and 34: Fig. 101If using the Model 2340 Art
Page 35 and 36: SETTING THE CONDYLAR GUIDANCE OF TH
Page 37 and 38: Fig. 113Lubricate the rounded end o
Page 39 and 40: Fig. 120Move through all intermedia
Page 41: III. Preparing Face-Bow Armamentari
Page 44 and 45: Fig. 138The QUICKMOUNT transfer bas
Page 46 and 47: Fig. 146Adjust the inclination of t
Page 48 and 49: XII. Remounting CastsFig. 154After
Page 52 and 53: Reminders And Suggestions1. When se
Page 54 and 55: 2000 SERIES ARTICULATOR PARTS LISTS
Page 56 and 57: WHIP MIX FACE-BOW PARTS LISTSModel
Page 58 and 59: MODELS 9175/9185/9195FACE-BOWSFOR I
Page 60 and 61: BibliographyThe following bibliogra
Page 62 and 63: NOTES______________________________
Page 64: For additional information, contact

2000 Series Articulator and QuickMount Face-Bow ... - Whip Mix

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?