2010 Rail Manual - Dye Paintball

RAIL BOARDSETTINGS AND FUNCTIONSRAIL BOARDSETTINGS AND FUNCTIONSTURNING THE RAIL ON AND OFFTo turn on the RAIL, press and hold the power button untilthe LED’s turn blue. The blue light indicates board boot up.After the boot up sequence, the LED’s will turn either RED(no ball) or GREEN (ball ready to fire). To turn the RAIL off,press and hold the power button until the LED’s turn off.NOTE: The RAIL automatically switches off after 10minutes of non-use.When you turn on the marker in normal operation mode with the power button, the light colorsmean the following:Blue - Boot sequenceRed - Breech is clear, no ball detected inside the RAIL (eye is on)Green - Ball in breech, ready to fire (eye on)Blinking Red - Eye is turned offBlinking Green - Eye failure, eye is blocked or dirty (see RAIL Eye, page 26)Blinking Blue - Indicates a low battery; battery should be changed as soon as possibleFIRING THE RAILAs soon as the marker is turned on and the LED’s turn fromblue to either red or green, the RAIL is ready to fire. If thereis no ball and the LED’s are RED, you need to hold thetrigger for 1 second to force the RAIL to fire once. If there isa paintball inside the breech and the LED is green, just pressthe trigger to fire the marker.LED LIGHT INDICATORThe RAIL uses two super bright LED’s mounted on the circuitboard inside the grip frame. These two lights are used toprovide information to the user about the RAIL. They willalways show the same information and it does not matterwhich LED you look at. One is mounted behind the RAIL logoon the left side of the grip panel. The other one can be seenby looking at the top left side of the grip frame while holdingthe RAIL in the position you would while playing a game.W W W . P R O T O P A I N T B A L L . C O MNOTE: The eye is always activated when you turn the marker on.To turn off the eye feature press and hold the bottom button until the LED light starts blinkingRed indicating the eye feature is turned off.When servicing your marker:• Make sure a barrel sock is fitted to the RAIL.• Make sure your hopper is removed from the RAIL.• Make sure there are no paintballs in the breech of the RAIL.• Always remove the first stage regulator and relieve all residual gaspressure from the RAIL before disassembly.• The RAIL can hold a small residual charge of gas, typically 2 shots, withthe first stage regulator removed. Always discharge the marker in a safedirection to relieve this residual gas pressure.6 7W W W . P R O T O P A I N T B A L L . C O M