User manual - teles

VIERLING
2.2.12 Configuration steps in Firmware Tools
Note: This section applies only to ECOTEL® ISDN2-1 and
ECOTEL ® ISDN2-120 lite. The corresponding configuration
steps for other ECOTEL ® types are to be done in the SIM
Management module.
» Switch to the Firmware Tools module:
Tools > Start > Firmware Tools
» Remove all of the SIM cards!
(if they are inserted)
Warning: When it is powered on and when a SIM card is
inserted, ECOTEL ® will attempt to log in to the network
using the SIM card. Since ECOTEL ® does not yet have
the valid SIM PIN, this will fail.
After two failed attempts, ECOTEL ® will block any further
attempts. In order to unblock the device, insert the SIM
card into a mobile phone and type in the correct PIN. This
will reset the counter for failed attempts..
» Enter the SIM PINs:
GSM parameters > Module 1 >
Click on Enter PIN
Enter the PIN for the SIM card to be used in the relevant
module
» Repeat this procedure for each of the remaining modules
» Insert the SIM cards
For additional information, see:
6.5 Firmware Tools module
Page 36 Edition 4.1-EN – 20070730 ECOTEL ® VoIP/ISDN2-1/ISDN2-2