User manual - teles

More documents

Recommendations

Info

VIERLING 3.2.3 Connection to the external S0 port/PTMP Fixed network TE NT ECOTEL Antennas Important: Synchronization problems can occur in this configuration. ECOTEL ® can be operated on an external S0 connection of a PBX. Here, ECOTEL ® must be configured as the network termination (NT). Preferably, the ISDN BRI2 port should be used. In this case, the line is operated in PTMP mode (point-tomultipoint). Page 48 Edition 4.1-EN – 20070730 ECOTEL ® VoIP/ISDN2-1/ISDN2-2
ISDN configuration: VIERLING BRI1 BRI2 (100 Ohm) Jack - NT Activate Interface No Yes L1 mode ... Network Connection ... PTMP L2 mode ... Network L3 mode ... Network Entries in the routing table: All calls from BRI2 go to GSM All calls from GSM go to BRI2 (oI2d*#) n G:d (oGd*#) n I2:d Note: This configuration is the factory default for ECOTEL ® . ECOTEL ® VoIP/ISDN2-1/ISDN2-2 Edition 4.1-EN – 20070730 Page 49
Page 1 and 2: ECOTEL ® VoIP ECOTEL ® ISDN2-1 EC
Page 3 and 4: Content VIERLING 1 Introduction....
Page 5 and 6: VIERLING 5 Introduction to the rout
Page 7 and 8: VIERLING 6.5.4 Firmware Tools: Firm
Page 9 and 10: VIERLING 9.7 Special notes about EC
Page 11 and 12: 1.1 Overview: Please read this firs
Page 13 and 14: 1.2 Safety instructions VIERLING Th
Page 15 and 16: Repairs VIERLING Repairs must be pe
Page 17 and 18: 2 Getting started VIERLING ECOTEL
Page 19 and 20: 2.2 Installation guideline VIERLING
Page 21 and 22: 2.2.3 Connecting the device VIERLIN
Page 23 and 24: VIERLING » Open Windows device man
Page 25 and 26: 2.2.6 Configuration steps in Servic
Page 27 and 28: VIERLING 2.2.7 Configuration steps
Page 29 and 30: VIERLING 2.2.8 Configuration steps
Page 31 and 32: 2.2.9 Configuration steps in User R
Page 33 and 34: 2.2.10 Configuration steps in Routi
Page 35 and 36: VIERLING » Repeat these steps for
Page 37 and 38: 2.2.13 Checking for proper operatio
Page 39 and 40: 3 Operating modes VIERLING ECOTEL
Page 41 and 42: Overview of possible ISDN configura
Page 43 and 44: VIERLING Note: The choice of whethe
Page 45 and 46: ISDN configuration: VIERLING BRI1 B
Page 47: ISDN configuration: VIERLING BRI1 B
Page 59 and 60: ISDN configuration: BRI1 BRI2 (100
Page 61 and 62: ISDN configuration, variant 1: As i
Page 63 and 64: 3.3.2 Call routing via the VoIP por
Page 65 and 66: ISDN configuration: As in the follo
Page 67 and 68: 3.3.5 Box-to-box operation VIERLING
Page 69 and 70: VIERLING 3.4.2 Call hold switching
Page 71 and 72: VIERLING 3.4.4 SIP outbounds (SIP p
Page 73 and 74: 3.4.5 SIM management VIERLING Note:
Page 75 and 76: VIERLING 4 Calling number = Number
Page 77 and 78: 3.4.7 Automatic call forwarding Not
Page 79 and 80: 3.4.8 Callback request via SMS VIER
Page 81 and 82: VIERLING 4 Usage of the configurati
Page 83 and 84: File management VIERLING There are
Page 85 and 86: VIERLING via GSM to the devices whi
Page 87 and 88: SIM Management (not for ECOTEL ® I
Page 89 and 90: VIERLING 4.3.1 Connecting via IP (L
Page 91 and 92: 4.3.2 Connecting via modem VIERLING
Page 93 and 94: Setting up the device » In the Ser
Page 95 and 96: 4.4 Editing the configuration files
Page 97 and 98: 4.5 Generating traces VIERLING Trac
Page 99 and 100:
VIERLING » Click on Save Trace. Se
Page 101 and 102:
5 Introduction to the routing table
Page 103 and 104:
VIERLING unchanged, parts of it can
Page 105 and 106:
5.3 Strategy for the routing table
Page 107 and 108:
5.4 Outgoing calls VIERLING The rou
Page 109 and 110:
Example 3: VIERLING Dial the phone
Page 111 and 112:
Example 8: Invalid entry Dial the p
Page 113 and 114:
Example 5: VIERLING When using spee
Page 115 and 116:
5.4.4 Calls to an arbitrary extensi
Page 117 and 118:
5.5 Incoming calls VIERLING The rou
Page 119 and 120:
Example 3: VIERLING When called by
Page 121 and 122:
5.5.2 Calls to a specified MSN Exam
Page 123 and 124:
5.6.1 Routing based on the interfac
Page 125 and 126:
5.6.2 B-channel routing VIERLING By
Page 127 and 128:
5.6.4 Routing to a specific GSM net
Page 129 and 130:
5.8 Date- and time-dependent routin
Page 131 and 132:
Example 4: VIERLING The routing ent
Page 133 and 134:
5.9.1 Dialing callback with disconn
Page 135 and 136:
5.9.2 Dialing callback without disc
Page 137 and 138:
5.9.4 Non-dialing callback without
Page 139 and 140:
5.11 Default configuration VIERLING
Page 141 and 142:
5.12 User scenario VIERLING A typic
Page 143 and 144:
VIERLING 6 Reference: Operating ele
Page 145 and 146:
6.2 Service Gear module VIERLING Th
Page 147 and 148:
6.2.1 Service Gear: Main window VIE
Page 149 and 150:
6.2.2 Service Gear: Properties Grou
Page 151 and 152:
VIERLING IP address IP address of t
Page 153 and 154:
6.2.4 Service Gear: Properties Mode
Page 155 and 156:
6.3 Gateway Configuration module VI
Page 157 and 158:
New... Open… Save VIERLING Opens
Page 159 and 160:
6.3.2 Gateway Configuration: Proper
Page 161 and 162:
6.3.3 Gateway Configuration: BRI 1/
Page 163 and 164:
When end of dialing is reached, sta
Page 165 and 166:
Keep in the list the entries of An
Page 167 and 168:
Change bearer capability of GSM cal
Page 169 and 170:
VIERLING 6.3.8 Gateway Configuratio
Page 171 and 172:
Overall calltime limit Use limit of
Page 173 and 174:
VIERLING 6.3.10 Gateway Configurati
Page 175 and 176:
VIERLING The CLIR also be used sele
Page 177 and 178:
Page 179 and 180:
6.3.13 Gateway Configuration: SIP I
Page 181 and 182:
Page 183 and 184:
Outbound device (1st line: Domain d
Page 185 and 186:
VIERLING With username The user nam
Page 187 and 188:
6.3.17 Gateway Configuration: Devic
Page 189 and 190:
6.4.1 Routing Table: Main window VI
Page 191 and 192:
6.4.2 Routing Table: Routing VIERLI
Page 193 and 194:
6.4.3 The routing syntax VIERLING T
Page 195 and 196:
VIERLING Indication of the permiss
Page 197 and 198:
VIERLING G{} The call is set up via
Page 199 and 200:
6.4.4 The Routing Wizard VIERLING C
Page 201 and 202:
VIERLING (selected port) The origin
Page 203 and 204:
VIERLING Note: You can also just do
Page 205 and 206:
6.4.5 Routing Table: Remote Connect
Page 207 and 208:
6.5.1 Firmware Tools: Main window V
Page 209 and 210:
6.5.3 Firmware Tools: Security Code
Page 211 and 212:
6.5.4 Firmware Tools: Firmware Down
Page 213 and 214:
VIERLING A list of the WAVE files w
Page 215 and 216:
Delete Transferred Files Upload fro
Page 217 and 218:
VIERLING Warning: Always modify thi
Page 219 and 220:
VIERLING Delete Deletes the selecte
Page 221 and 222:
Long-Term Traces Opens the Long-Ter
Page 223 and 224:
6.5.10 Firmware Tools: Remote Conne
Page 225 and 226:
6.6 Basic Configuration module VIER
Page 227 and 228:
6.6.2 Basic Configuration: ISDN Int
Page 229 and 230:
6.6.3 Basic Configuration: IP Conne
Page 231 and 232:
Domain name (preferred) VIERLING Th
Page 233 and 234:
6.7 Monitor module Note: This modul
Page 235 and 236:
6.7.2 Monitor: Channels VIERLING Ca
Page 237 and 238:
VIERLING Avg duration [s] Average c
Page 239 and 240:
Remove released connections after V
Page 241 and 242:
Display options h:mm:ss m:ss s VIER
Page 243 and 244:
Groups of SIM cards VIERLING The SI
Page 245 and 246:
6.8.2 SIM Management: SIM Cardholde
Page 247 and 248:
Clock model in seconds Lock to pref
Page 249 and 250:
VIERLING 6.8.4 SIM Management: GSM
Page 251 and 252:
6.8.5 SIM Management: Device VIERLI
Page 253 and 254:
6.9.1 User Registration: Main windo
Page 255 and 256:
VIERLING Edit... Opens the User Reg
Page 257 and 258:
6.10.1 IO Configuration: Main windo
Page 259 and 260:
6.10.3 IO Configuration: IO Channel
Page 261 and 262:
Send SMS if signal is... VIERLING a
Page 263 and 264:
6.10.4 IO Configuration: Device VIE
Page 265 and 266:
7.1 Overview: What ECOTEL users mus
Page 267 and 268:
VIERLING For all other applications
Page 269 and 270:
7.2.3 Setting up fixed connections
Page 271 and 272:
7.3.2 Routing calls to a fixed exte
Page 273 and 274:
7.3.4 Call forwarding VIERLING Duri
Page 275 and 276:
Switching between the different cal
Page 277 and 278:
8 Additional topics and background
Page 279 and 280:
8.2 Interpretation of the interface
Page 281 and 282:
Modem VIERLING In everyday terms, t
Page 283 and 284:
8.4 General information about VoIP
Page 285 and 286:
VIERLING UAC. As a general rule, in
Page 287 and 288:
8.4.2 Codec VIERLING A codec (COmpr
Page 289 and 290:
9 Special hardware-related issues V
Page 291 and 292:
BRI 1 Off ISDN port 1 is deactivate
Page 293 and 294:
9.1.2 Display elements on the housi
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
9.2 Interfaces on the housing VIERL
Page 301 and 302:
I/O VIERLING RJ-45 jack with six in
Page 303 and 304:
9.3 Interfaces BRI1, BRI2 VIERLING
Page 305 and 306:
9.3.1 BRI1 connection VIERLING In t
Page 307 and 308:
9.4 Antennas VIERLING Depending on
Page 309 and 310:
SIM cardholders VIERLING Note: This
Page 311 and 312:
9.5.1 SIM8 cardholder VIERLING The
Page 313 and 314:
VIERLING ECOTEL ® VoIP/ISDN2-1/ISD
Page 315 and 316:
9.5.4 SIM emulation board VIERLING
Page 317 and 318:
Wiring the BRI interfaces VIERLING
Page 319 and 320:
10 Technical Details VIERLING ECOTE
Page 321 and 322:
Tones SYS016a.wav Sinewave 425 Hz D
Page 323 and 324:
10.2 Package contents 10.2.1 Packag
Page 325 and 326:
10.2.3 Package contents ECOTEL ISDN
Page 327 and 328:
VIERLING 10.3.2 Spare parts / Acces
Page 329 and 330:
10.4 Specifications Dimensions VIER
Page 331:
10.6 Conditions for using the softw
show all

User manual - teles

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?