ATR620 - Logitron

1 Input START at impulse (>= 150 msec)2 Input STOP at impulse (>= 150 msec)3 Input START/STOP at impulse (>= 150 msec)4 RUN input when active. The controller executes the cycleprogrammed on 3 rd digit (or function selected on 4 th digit)until contact is closed (or open).5 Temporary cycle block, flashing(Normally connected to the door switching).6 Cycle stop with acoustic and visual signal.Visualize for IN1 or for IN2, buzzer isactive until is pressed.7 Input HOLD.Cycle is stopped and setpoint can be modified by frontalkeys.8 Impulse input for step advancement (one step forwards)during cycle.2 nd Digit – Type of contact0 Activation with closed contact1 Activation with open contact3 rd Digit – Function or cycle to activate0 Activate function selected on 4 th digit1…9 Activate cycle no.1…94 th Digit – Special function to activate0 “Simple controller”1 Remote controller (if P-01/ 4 th Digit selected as 0)2 Manual control(modify percentage of control output 0…100%)3 Last executed cycle4 Simple controller (also during cycle execution)P-19 Configuration Auto-tuning and visualization of stepSelect on which process Autotuning will be completed and whichvalues will be visualized in RUN mode.1 st Digit – Configuration Autotuning0 Autotuning only on process 11 Autotuning only on process 22 Autotuning both on process 1 and process 22 nd Digit – Control of heating elements power80