Download Manual for Aero-naut Buecker Jungmeister 133

Bücker 133 Jungmeisterdepends on the power available.Initiate the landing approach with the motor still running, and flare out gently close to the ground; chopthe throttle, and it will settle neatly by itself.We hope you have many hours of pleasure flying your new model.Happy landings!“aero-naut” ModellbauBü-133 Jungmeister parts listPart Description No. Material Dimensions in mmNo.off1 Fuselage 1 GRP Ready made2 Motor cowl 1 GRP Ready made3 Fuselage tail post 2 Plywood 3 mm, die-cut4 Motor bulkhead 1 Plywood 3 mm, die-cut5 Motor bulkhead 1 Plywood 3 mm, die-cut6 Cabane plate 4 Plywood 3 mm, die-cut7 Sleeve Brass 2.5 / 4 Ø8 Motor cowl rail Lime 8 x 8, as plan9 Cabane strut 2 Steel Ready made10 Cabane strut 2 Steel Ready made11 Cabane strut brace 2 Steel Ready made12 Triangular strip Balsa 5 x 25, as plan13 Profiled fairing Balsa Profiled /strip14 Undercarriage brace 1 Plated steel Ready made15 Undercarriage cross-piece 1 Plated steel Ready made16 Rubber band, undercarriage 1 Rubber Ready made17 Undercarriage retainer strap 4 Plastic Ready made18 Self-tapping screw 12 Steel 2.2 Ø x 9.519 Wing mount plate 4 Plywood 3, die-cut20 Wire “star”, motor Plated steel 1.2 Ø, as plan21 Tailwheel unit support 2 Plywood 3, die-cut22 Instrument panel 1 Plastic Ready made23 Pilot’s seat 1 Plastic Ready made24 Headrest 1 Plastic Ready made25 Velcro tape Plastic Ready made26 Half-former 1 Plywood 3, die-cut27 Half-former 1 Plywood 3, die-cut28 Bowden cable inner sleeve 3 Plastic 1 / 2 Ø, as plan29 Steel rod 3 Steel 0.8 Ø, as plan30 Bowden cable outer sleeve 1 Plastic 2 / 3 Ø, as plan30.1 Threaded sleeve 4 Metal 3 / 8 Ø, M231 Main undercarriage unit 1 Steel Ready made32 Rear undercarriage unit 1 Steel Ready made33 Balloon wheel 2 Plastic 72 Ø, ready made34 Wheel bush Brass 3 / 4 Ø35 Mudguard 2 Plastic Ready made36 Mudguard support bar Plated steel 1.2 Ø, as plan37 Collet 4 Brass Ready made38 Undercarriage fairing 2+2 Plastic Ready made39 Dummy engine 1 Plastic Ready made40 Exhaust collector ring 1 Plastic Ready made41 Exhaust 1+1 Plastic Ready made42 Half-rib 8 Plywood 3, die-cut43 Servo mount, side 2 Plywood 3, die-cut44 Servo mount, side 2 Plywood 3, die-cut45 Servo mount 2 Plywood 3, die-cutBuilding Instructions Bü-133 Jungmeister8