VRIOGS 010.3 RevA - Public Transport Victoria

VRIOGS 010.3 Revision A 39SECTION 13.0 REGULATIONS AND PUBLISHED STANDARDSSubstation Design requirements will comply with the requirements of the Department’sTraction Substation Design Standard 2007, unless noted otherwise.All designs shall comply with all relevant regulations of Government and SemiGovernment Authorities.In particular, the proposed designs shall comply with the provisions of current editionsof the following acts, codes, regulations and standards.13.1 ACTS, CODES, REGULATIONS AND PUBLISHED STANDARDS• Historic Building Act.• Occupational Health & Safety Act.• Building Code of Australia.• Victorian Building Regulations.• ROA Code “For the installation of other party’s services and Pipelines withinRailway Boundaries”.• Code of Practice for the Defined Interstate Rail Network, January 2003.• Victorian Service & Installation Rules.• Electricity Distribution Code - Essential Services Commission - Victoria• Australian StandardsAS Reference TitleAS 1028 Power reactors and earthing transformers.AS 1033 High voltage fuses (for rated voltages exceeding 1000 V).AS 1104 Informative symbols for use on electrical and electronicequipment.AS 1170 Minimum design loads on Structures (Parts 1, 3 and 4).AS 1243 Voltage transformers for measurement and Protection.AS 1306 High Voltage a.c. switchgear and control gear –Disconnectors (isolators) and earthing switches.AS 1384 Transducers for Electrical Measurement.AS 1428 Design for Access and Mobility.AS 1429.1 Electric cables – Polymeric insulated.AS 1675 Current transformers – Measurement and protection.AS 1746 Conductors – Bare overhead – Hard – drawn copper.AS 1767 Insulating liquids – Specification for unused mineralinsulating oils for transformers and switchgear.NOTE:This document is controlled only when viewed on the DOT Engineering Standards website.Any other copy of this document is uncontrolled, and the content may not be current.