1961-64 Ford Pickup Truck - Classic Auto Air

More documents

Recommendations

Info

Locate in the hardware sack kit the firewall cover plate.Attach over heater tubes using the original hardware.Locate support bracket under the glove boxopening.Attach to bottom of instrument panel using(1) #10 x ¾” tek screw supplied.Locate 2” dia. flex hose that is attached to the defrosthose adaptors.Attach over the defrost duct as shown.Route Wire Harness and the control cable that is attached tothe evaporator over the dash brace.10
Locate the Blower Switch and (2) switch nuts. Attach blower switch to the wire harness using thediagram below.BROWN WIRELocate brown wire that attached to theoriginal blower switch. Cut off the terminaland attach a ¼” male spade connector.Locate red / white stripped wire on the wireharness and plug it into the brown wire.Locate the Temperature Control cable inthe control sack kit. Route the cable backtowards firewall. You will find the originalhole that supported the original heaterassembly. Pass cable through the hole andthen out through firewall and over to theheater tubes.BLOWER SWITCHWIRING DIAGRAM <strong>1961</strong>-<strong>64</strong> FORD TRUCKWIRING DIAGRAM / 1966 FORD PICKUP11
Page 1 and 2: specializing in “AIR CONDITIONING
Page 3 and 4: specializing in “AIR CONDITIONING
Page 5 and 6: Also remove (3) nuts that attach th
Page 7 and 8: Locate on top of the dash (2) defro
Page 9: The evaporator has A/C tubes that w
Page 13 and 14: Locate in kit. Passenger side Ball
Page 15 and 16: Remove original fan, fan shroud, dr
Page 17 and 18: Place condenser assembly from engin
Page 19 and 20: Locate the Discharge Hose.Attach st
Page 21: IMPORTANTCAUTION: WATER VALVE MUST

1961-64 Ford Pickup Truck - Classic Auto Air

Create successful ePaper yourself

Delete template?

Save as template?