1961-64 Ford Pickup Truck - Classic Auto Air

More documents

Recommendations

Info

Located on top of heater looking through theglove box opening.Disconnect wires from the heater.Remove and discard heater assembly..Located on the instrument panel is the originalheater blower switch and cable combination.Remove the control knob as shown.Located on back of the switch is a Brown wire.Disconnect from the switch. This is the power wirefor the new heater / a/c unit.Remove the entire assembly along with originalwire harness and discard.6
Locate on top of the dash (2) defrost outlets. Remove the cover and the flex hose adapter.Retain the cover and all of its hardware. Discard flex hose adaptor.Locate on passenger kick panel thefresh air inlet door. Carefully bend thecable bracket up 90 deg. as shown.REMOVEINSULATI0NBEND CABLE BRACKETUP. AT THIS POINT7”Located on the inside of the firewall behind the glove box.Remove 7” of the original insulation. As shown.7
Page 1 and 2: specializing in “AIR CONDITIONING
Page 3 and 4: specializing in “AIR CONDITIONING
Page 5: Also remove (3) nuts that attach th
Page 9 and 10: The evaporator has A/C tubes that w
Page 11 and 12: Locate the Blower Switch and (2) sw
Page 13 and 14: Locate in kit. Passenger side Ball
Page 15 and 16: Remove original fan, fan shroud, dr
Page 17 and 18: Place condenser assembly from engin
Page 19 and 20: Locate the Discharge Hose.Attach st
Page 21: IMPORTANTCAUTION: WATER VALVE MUST

1961-64 Ford Pickup Truck - Classic Auto Air

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?