General Information Gates/Rohloff - Koga Signature

mountingMinimize the distance betweenthe axle of the bottom bracket andthe rear axle so that the belt can befitted to the front sprocket withouttension. The tools requird to reducethe distance may vary dependingupon manufacturer. Always followthe instructions of the particularmanufacturer. In this example, the rear wheel is moved towards the bottom bracketby horizontally slidable dropouts. It might be necessary to loosen the screws of thedisc brake caliper. When you reach the smallest distance between the axle of thebottom bracket and the rear axle, fit the belt to the front sprocket as well.4. Devices used to tension the belt may vary by manufacturer. Always follow theinstructions of the particular manufacturer. In this example, you now tension thebelt on the drive side, using the slidable dropouts and the tensioning bolts insidethe dropouts. After tensioning the right side (drive side), until the wheel sits evenlybetween both chainstays.Please Note:Never try to pry the belt on, or “roll” it on by rotating the cranks. This may cause innerstructual damage which will result in the belt no longer being useful.The handling illustrated above can damage the system!12