General Information Gates/Rohloff - Koga Signature

More documents

Recommendations

Info

4forFrame builders• Frame requirements when mounting the Gates Carbon Drive• Possibilities for tensioning and adjustment• Straightness and stiffness of the frame34
for Frame buildersFrame requirements when mounting the Gates Carbon DriveOpening the frameA specific rear triangle is required for mounting the Gates Carbon Drive System. Sincethe belt cannot be separated and rejoined like a bike chain, it has to be possible to openthe frame at the rear triangle. This opening should allow a gap of at least 8mm. There areseveral possible solutions, depending upon desired style. Illustrations1 and 2 show a framewith the opening at the dropout. A separation of the right chainstay or at the seatstay ofthe frame is also possible. (Illustration 3).4Illustration 1:Opening the frame tomount the beltPossibilities for tensioning and adjustmentIt has to be possible to tension and adjust the belt after it is mounted in the frame. Thisispossible through the use of either adjustable dropouts (illustration 2) or with an eccentricadjuster around the bottom bracket.However, the safety of the belt can only be guaranteed if the correctly adjusted tension isnot altered when the rear wheel is dismounted (in the case of a puncture, for example). Theframe construction must allow for this.www.carbondrivesystems.com35
Page 2 and 3: ContentCongratulations! 4For your s
Page 4 and 5: first stepsCongratulations!Thank yo
Page 7: first steps1Mounting the tensioned
Page 11 and 12: mountingMounting the Gates Carbon D
Page 13 and 14: mounting2Illustration 3:Correct ali
Page 15 and 16: mountingChecking the belt tension2P
Page 17 and 18: mountingChecking the belt tension w
Page 19 and 20: mountingaxle. If the Snubber is loc
Page 21 and 22: mounting2Shim ring for bottombracke
Page 23 and 24: mountingMounting the Gates Carbon D
Page 25: mountingLubricate the inner thread
Page 28 and 29: mountingIllustration 8:Mounting the
Page 30 and 31: 3exchange• When does the Gates Ca
Page 32 and 33: exchangeIllustration 2:Wearing off
Page 36 and 37: for Frame buildersIllustration 2:Ex
Page 39 and 40: atio overview19 Teeth rear 20 Teeth
Page 41 and 42: atio overviewSprocket-size combinat
Page 43: Find more information for Europe:Un

General Information Gates/Rohloff - Koga Signature

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?