General Information Gates/Rohloff - Koga Signature

More documents

Recommendations

Info

mountingSnubber version for quickrelease, vertical dropout usewithout a derailleur hangerRemoving the SnubbersFollow the instructions for Mounting the Snubber in the reversed order.Mounting the Gates Carbon Drive Front SprocketFront sprockets are available for the Gates carbon Drive System to fit both4 and 5 arm crank-sets.Front Sprocket versionsTeeth Description Part Number46 4-Arm 104mm BC 11464AF1050 4-Arm 104mm BC 11504AF1055 5-Arm 130mm BC 11555AF1060 5-Arm 130mm BC 11605AF10TeethFront Sprocket (shownhere: 55 tooth/5-Arm)FlangeLocating Holes20
mounting2Shim ring for bottombracketArt.Nr. 11201023Shim ring 0.5mmArt.Nr. 11201020Shim ring 1mmArt.Nr. 11201022Mounting the Front Sprocket at the crank adapterThe sprocket is put over the crank arm and affixed with the sprocket bolts (which wereincluded with your crankset). As shown in illustration 1, the flange of the sprocket is turnedoutward. To guarantee proper operation of the Gates Carbon Drive System, both sprocketsneed to be exactly aligned with each other (illustrations 2 and 3). The belt alignment cannotbe adjusted on the rear sprocket of the Rohloff SPEEDHUB 500/14. Therefore, you canonly adjust it with the position of the front sprocket. The included shim rings have beendesigned to facilitate this adjustment. For some bottom brackets it is possible to adjust thealignment with shim rings (illustration 4). Please note the mounting instructions from theparticular bottom bracket manufacturer.Chain-ring NutCrank ArmIllustration 1:Mounting the frontsprocketChain-ring BoltMounting Shims(if required)Front Sprocketwww.carbondrivesystems.com21
Page 2 and 3: ContentCongratulations! 4For your s
Page 4 and 5: first stepsCongratulations!Thank yo
Page 7: first steps1Mounting the tensioned
Page 11 and 12: mountingMounting the Gates Carbon D
Page 13 and 14: mounting2Illustration 3:Correct ali
Page 15 and 16: mountingChecking the belt tension2P
Page 17 and 18: mountingChecking the belt tension w
Page 19: mountingaxle. If the Snubber is loc
Page 23 and 24: mountingMounting the Gates Carbon D
Page 25: mountingLubricate the inner thread
Page 28 and 29: mountingIllustration 8:Mounting the
Page 30 and 31: 3exchange• When does the Gates Ca
Page 32 and 33: exchangeIllustration 2:Wearing off
Page 34 and 35: 4forFrame builders• Frame require
Page 36 and 37: for Frame buildersIllustration 2:Ex
Page 39 and 40: atio overview19 Teeth rear 20 Teeth
Page 41 and 42: atio overviewSprocket-size combinat
Page 43: Find more information for Europe:Un

General Information Gates/Rohloff - Koga Signature

Create successful ePaper yourself

Delete template?

Save as template?