NewAir AC-10100E / AC-10100H Portable Air ... - Air & Water

More documents

Recommendations

Info

Heating Function (For <strong>AC</strong>-<strong>10100H</strong> Only)1. When the air conditioner is in heating mode, ambient warm air is recycled and used to heatyour immediate area. The exhaust pipe will still need to be fitted onto the unit in orderfor the cold air to be removed.2. Continuous drain is compulsory while the unit is in heat mode. Working range for heatingfunction is 45 to 77 o F (7 ~ 25 o C). If the ambient temperature is lower than this range, the unitmay not work properly.All the functions can also be performed with the supplied remote control. The remotecontrol requires 2 AAA batteries to operate.Regulating air flow directionMove the air vent directly to adjust the air flow directionof the louvers.Please Note:1. To prolong the life of the compressor, after turning off the unit, please wait at least 3minutes before turning it back on.2. The cooling system will turn off if the ambient temperature is lower than the set temperature.However, the fan will continue operating at the set level. Once the ambient temperaturerises above the set temperature, cooling will resume.3. The heating system will turn off if the ambient temperature is higher than the settemperature. The ventilation fan will continue operating at the set level. Once the ambienttemperature drops below the set temperature, heating will resume.4. This machine is equipped with ANTI-FROST function. When using the heating function inlow temperature the heater will occasionally stop heating in order to melt any frost that hasaccumulated within the air conditioner. Normal operation will resume in a few moments.9
DRAINING THE UNITDuring the cooling process, some water will be extracted from the air and stored within the unit’swater reservoir.If the reservoir is full, both the compressor and motor will stop and the unit will beep (press anybutton to stop the beeping sound). The full water tank indicator light will also start flashing.To resume cooling, empty the reservoir by following these steps:1. Turn off the air conditioner and unplug itfrom the wall socket. To prevent waterleakage, avoid moving the unit when full.2. Place a container (such as a small pan)underneath the drain hole.3. Remove the drain knob & rubber plug fromthe drain hole and allow the water to drainout.4. When the container is almost full, replacethe rubber plug in the drain hole and emptythe water tray.5. Repeat until the unit is emptied.6. Replace the rubber plug and make sure it isfirmly in place.7. Turn the unit back on. The full tank indicatorlight should turn off.For Continuous Drainage:• Remove the drain knob and rubber plugfrom the drainage port and hold on to themfor future use.• Connect the drain tube to the water outletas shown. Place the other end of draintube into a drain.10
Page 3 and 4: ELECTRICAL SAFETY• This appliance
Page 5 and 6: INSTALLATIONExtendable window kit1.
Page 7 and 8: Installation of the Carbon Filter1.
Page 9: Setting the Model/Function:Press th
Page 13 and 14: MAINTENANCE INSTRUCTIONSAlways unpl
Page 15 and 16: 13TECHNICAL SPECIFICATIONSModel Num

NewAir AC-10100E / AC-10100H Portable Air ... - Air & Water

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?