EN 14766:2005 - 64_e_stf - Baltik vairas

EN 14766:2005 (E)Keyg Distance between the upper, external part of the handlebar-stem clamp and the upper partof the fork-stem1 Stem-extension2 Extended fork-stem3 Spacer-rings4 Bearing assembly5 Head-tube6 Stem-extension to stem clampFigure 17 — Clamping between the handlebar stem-extension and fork-stem4.7.4 Handlebar stem-extension to fork-stem – clamping requirementsThe distance g, see Figure 17, between the upper, external part of the handlebar stem clamp and the upper, innerpart of the fork stem to which the handlebar is clamped shall not be greater than 5 mm.The upper part of the fork-stem to which the stem-extension is clamped shall not be threaded.The dimension g shall also ensure that the proper adjustment of the steering system can be achieved.NOTE For aluminium and carbon-fibre fork-stem, the avoidance of any internal device that could damage the internalsurface of the fork-stem is recommended.4.7.5 Steering stabilityThe steering shall be free to turn through at least 60° either side of the straight-ahead position and shall exhibit notight spots, stiffness or slackness in the bearings when correctly adjusted.A minimum of 25 % of the total mass of the bicycle and rider shall act on the front wheel when the rider is holdingthe handlebar grips and sitting on the saddle, with the saddle and rider in their most rearward positions.NOTE Recommendations for steering geometry are given in Annex B.4.7.6 Steering assembly – static strength and security tests4.7.6.1 Handlebar-stem – lateral bending test4.7.6.1.1 GeneralThis test is intended for stem manufacturers who do not produce handlebars.35