Sauer-Danfoss series OTP steering columns

OTP Steering Columns / OVPL, OVR Valve BlocksTechnical InformationSensor Type SASAInstallation (continued)Electric connection through cable mounted with an AMP Connector.AMP type 2-967059-1Pin 1 CAN-LowPin 2 +supply voltagePin 3 GndPin 4 CAN-HighMating connector assemblyAMP type 2-965261-1JPT contacts 2-962915-1Wire sealing 828904-1Recommended wiring practice• Protect all wires from mechanical abuse.• Use a wire gauge that is appropriate for the sensor electrical mating connector.• Use wire with abrasion resistant insulation.• Separate high current wires such as feeds to solenoids, lights, alternators, or fuelpumps from control wires. Recommended minimum separation is 300 mm [11.8 in].• Run wires along the inside of or close to metal machine frame surfaces wherepossible. This simulates a shield which minimizes the effects of EMI/RFI radiation.• Do not run wires near sharp metal corners. Run wires through grommets whenrounding a corner.• Provide strain relief for all wires.• Avoid running wires near moving or vibrating components.• Avoid long, unsupported wire spans.• All sensors have dedicated wired power sources and ground returns. They should beused.• Twist sensor lines about one turn every 100 mm [3.94 in].• Use wire harness anchors that will allow wires to float with respect to the machineframe rather than rigid anchors.11015554 • Rev AB • May 200849