grippers & rack and pinion rotary actuators - Industrial and Bearing ...

SWITCHESAvailable for use on all Gripper and Rack &Pinion Rotary Actuator models, these switchesare activated by the cylinder’s internal pistonmagnet assembly. DC Reed, Hall-effect and ACTriac switches contain reverse polarity protection.(Only Hall-effect switches are available for RotaryActuators.)DC Reed Switches are designed for signalling end-of-strokeposition to devices such as programmable controllers. Theycan be used to operate dc relays and solenoids if a protectioncircuit is used and if current and voltage limits are observed.Hall-effect switches are available in either sinking type(NPN), or sourcing type (PNP). They are designed to signaldevices such as programmable controllers, dc loads, and TTLor CMOS circuits.ACTriac ReedSwitches aredesigned for signalling end-ofstrokeposition to devices such as programmable controllers.They can be used to operate ac relays and solenoids if aprotection circuit is used and if current and voltage limits areobserved.REED SWITCHESSee page 33 for mounting dimensions.NOTE: Cable is UNSHIELDED. Reedswitches can be used to operate relaysand solenoids if a protection circuit isused and if current, wattage andvoltage limits are observed. (Call thefactory for more information.)NOT AVAILABLE FOR ROTARYACTUATORS(+)(-)OR(+)(-)REED SWITCH, FORM AWIRING DIAGRAMLOADLOADCOMMONNORMALLY CLOSEDNORMALLY OPENBROWN(+)BLUE(-)BROWN(+)BLUE(-)BROWNBLACKBLUEREEDSWITCHREEDSWITCHREED SWITCH, FORM CWIRING DIAGRAMREEDSWITCHSPECSCONTACTSCONTACT RATINGINPUTVOLTAGEDC REED SWITCH SPECIFICATIONSREEDSWITCH – FORMSingle-pole, single-throw,normally open10 Watts, maximum current 500mA (not toexceed 10VA) (Refer to Temperature vs.Current and Voltage Derating charts.)A* Data available from manufacturer.REED SWITCH – FORMSingle-pole, double-throw, normally-open /normally-closed3 Watts, maximum current 250mA (not toexceed 3VA) (Refer to Temperature vs.Current and Voltage Derating charts.)200Vdcmaximum120Vdc/ac maximumR ESISTANCE0 .1Ω Initial (Maximum)0.1Ω Initial (Maximum)RELEASETIME1.0mSec. maximum1.0 mSec. maximumO PERATING TIME 0 .6 mSec. maximum (including bounce)0.7 mSec. maximum (including bounce)O PERATING TEMP. - 40° F (-40° C) to 158° F (70° C)-40° F (-40° C) to 158° F (70° C)INDICATOR*LIFE EXPECTANCYCABLEVOLTAGEDROPLOAD CURRENT (mA)PERFORMANCE DATARed LED lit when 4mA min.flows through contactsUp to 200,000,000 cycles(depending on load current,duty cycle andenvironmental conditions)5 meter with PVC jacket2m or 5m Quick-Disconnect with PVC jacketTEMPERATURE vs CURRENT600500400REED FORM A300200 REED FORM C10000 20 40 60 80 100 120 140 160OPERATING TEMPERATURE (°F)NoneUp to 200,000,000 cycles(depending on load current,duty cycle andenvironmental conditions)5 meter with PVC jacket2m or 5m Quick-Disconnect with PVC jacket2.6Vtypical @ 100mANAVOLTAGE A.C. or D.C. (mA)20015010050VOLTAGE DERATINGREEDFORM CREED FORM A00 100 200 300 400 500CURRENT D.C (mA)C31