Glenair Mighty Mouse Connectors Catalog - Interstate Connecting ...

AI85015Twinax Pin ContactAssembly InstructionsShieldedContactsPin Contact100 Ohm Parallel CableSTEP 1.2501. Strip cable to dimensions shown.Cable Shield(6.40)DielectricBe careful not to flare braid open.2. Pre-tin conductor and braid shield.3. Clean the solder joint with alcohol..150 (3.81).102 (2.60)ConductorsBSTEP 21. Insert cable into pin contact.Make sure center conductorlines up to the center pin.STEP 31. Install center conductors until theybottom-out in the contact cavity.Inspect to ensure cable shield is visiblethrough the inspection hole.2. Apply flux and solder through theinspection hole; remove residuesand contamination with alcohol aftersoldering.1. Install M23053/5-204 or M23053/6-204shrink tubing; cover solder areaand extend insulation by minimumof one wire diameter.1. Illustrates final assembly.STEP 4STEP 5Shrink Tubing© 2012 Glenair, Inc. CAGE Code 06324Printed in U.S.A.GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912B-31www.glenair.comE-Mail: sales@glenair.com