Engine Ã¢Â€Â“ Dismantle and Assemble (21 134 8) - Ford Scorpio

More documents

Recommendations

Info

Section Title34. Remove the crankshaft.NOTE: Four special bolts for securing the oilbaffle. Detach the main bearing caps. Lift out the crankshaft. Remove the rear oil seal. Remove the bearing shells and mark themfor reuse.S2104166Assemble35. Preparatory measures.Thoroughly clean all mating and bearingsurfaces and re-usable parts and checkthem for damage.xx/xx Model 00-01-12
Section TitleMeasure the cylinder boresNOTE: Machine or renew the cylinder block asnecessary.36. Measure the cylinder bores. Measure dimensions A, B, and X-Y andcompare them with the values in theTechnical Data. Ovality = X-Y Conicity = A-B10mmAXYBD210520610mmMeasure the piston diameterNOTE: Piston classification, if a piston has to berenewed.37. Measure the piston diameter. Measure the piston diameter at the top ofthe piston pin bore.D2105207xx/xx Model 00-01-13
Page 4 and 5: Section Title11. Remove the intake
Page 7 and 8: Section Title18. Remove the oil pre
Page 9 and 10: Section TitleS210402726. Remove the
Page 11: Section Title232. Remove the camsha
Page 15 and 16: Section TitleS210454142. Paint mark
Page 17 and 18: Section Title48. Check the cranksha
Page 19 and 20: Section Title51. Identification of
Page 21 and 22: Section Title57. Fit the crankshaft
Page 23 and 24: Section TitleNOTE: A locking clip i
Page 25 and 26: Section Title9 Nm71. Fit the coolan
Page 27 and 28: Section TitleNOTE: Fit the hydrauli
Page 29 and 30: Section Title83. Fit the oil pressu
Page 31 and 32: Section Title32 Nm9087. Fit the roc
Page 33 and 34: Section Title95. Fit the alternator

Engine Ã¢Â€Â“ Dismantle and Assemble (21 134 8) - Ford Scorpio

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?