Engine Ã¢Â€Â“ Dismantle and Assemble (21 134 8) - Ford Scorpio

More documents

Recommendations

Info

Section Title20 NmELS2105870Only engines with connecting rods and big-endbearing journals with the respectiveidentification codes 5AB and KX900.NOTE: Use the old bolts to measure thebearing clearance.54. Measure the big-end bearing clearance. Measure the big-end bearing clearance asdescribed in sub-operations 44. to 46. Renew the bearing shell(s) as necessary.NOTE: Check whether the connection rodshave the specified end float.NOTE: Use new bolts.55. Fit the big-end bearing caps. Lubricate the bearing shells, bearingjournals, threads and contact faces of theconnecting rod nuts with engine oil.NOTE: The connecting rods and their bearingcaps have the same numbers. Fit the big-end bearing caps with the bearingshells and tighten them.NOTE: The oil seal points outwards.56. Install the crankshaft pilot bearing.S210453521–044 Axx/xx Model 00-01-20
Section Title57. Fit the crankshaft rear oil seal. Lubricate the crankshaft running face andoil seal lip with oil. Support the special tool in a vice. Insert the oil seal with the open sideupwards and drive it in carefully as far as itwill go using the handle of a hammer. Fit the special tool with the oil seal to theengine. Drive in the oil seal evenly as far as it willgo. Swivel the engine.21–059 CS210451511 Nm58. Install the camshaft. Lubricate the camshaft bearings, thecamshaft and the thrust plate with oil. Screw in the sprocket bolt half way and fitthe camshaft.NOTE: The oil bore in the thrust plate must beat the bottom. Fit the thrust plate. Take out the sprocket bolt.S2104533xx/xx Model 00-01-21
Page 4 and 5: Section Title11. Remove the intake
Page 7 and 8: Section Title18. Remove the oil pre
Page 9 and 10: Section TitleS210402726. Remove the
Page 11 and 12: Section Title232. Remove the camsha
Page 13 and 14: Section TitleMeasure the cylinder b
Page 15 and 16: Section TitleS210454142. Paint mark
Page 17 and 18: Section Title48. Check the cranksha
Page 19: Section Title51. Identification of
Page 23 and 24: Section TitleNOTE: A locking clip i
Page 25 and 26: Section Title9 Nm71. Fit the coolan
Page 27 and 28: Section TitleNOTE: Fit the hydrauli
Page 29 and 30: Section Title83. Fit the oil pressu
Page 31 and 32: Section Title32 Nm9087. Fit the roc
Page 33 and 34: Section Title95. Fit the alternator

Engine Ã¢Â€Â“ Dismantle and Assemble (21 134 8) - Ford Scorpio

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?