Double Insulated 10" Bench Top Table Saw Instruction Manual

More documents

Recommendations

Info

CARTON CONTENTS12435 6 789Fig. 21. <strong>Saw</strong>2. Fence3. <strong>Table</strong> Insert4. Blade Guard and Spreader Assembly5. Blade Wrench (2)6. Miter Gauge7. Anchor Block Shim (3)8. Handle9. 1/4"-20x1-3/4" Screw6
ASSEMBLYFOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIREINSTRUCTION MANUAL.BLADE RAISING ANDLOWERING HANDWHEELInsert the 1-3/4" screw (D) Fig. 4, through handle (E).Assemble handle (E) to handwheel (A) by threadingscrew (D) clockwise into handwheel as shown in Fig. 5.Handle (E) should rotate freely on screw (D).DEFig. 4EDABLADE GUARD ANDSPREADER ASSEMBLYFig. 51. DISCONNECT MACHINE FROMPOWER SOURCE.2. THE BLADE GUARD AND SPREADERASSEMBLY MUST BE PROPERLY ALIGNED TO THESAW BLADE IN ORDER TO HELP PREVENTKICKBACK.3. Position the blade 90 degrees to the table and lockin place.BAFig. 64. Insert spreader end (A) Fig. 6, of blade guard intoanchor block (B). Push spreader (A) down into holderuntil you hear a click, indicating that the spreader issecured. NOTE: It is important that the spreader (A) bein the vertical position and pushed straight down into thespreader anchor block (B) during the assemblyprocedure.5. Fig. 7 illustrates the blade guard in place.Fig. 77
Page 4 and 5: ADDITIONAL SAFETY RULES FORTABLE SA
Page 8 and 9: 6. NOTE: The anchor block (B) Fig.
Page 10 and 11: OPERATING CONTROLS AND ADJUSTMENTSS
Page 12 and 13: 3. THE RIP FENCE MUST BE PARALLELTO
Page 14 and 15: OPERATIONSCommon sawing operations
Page 16 and 17: Fig. 39The dado head set (D) Fig. 4
Page 19 and 20: CONSTRUCTING A PUSH STICKWhen rippi
Page 21 and 22: NOTES21
Page 23: PORTER-CABLE • DELTA SERVICE CENT

Double Insulated 10" Bench Top Table Saw Instruction Manual

Create successful ePaper yourself

Delete template?

Save as template?