XC1008D-XC1011D - Emerson Climate Technologies

4.2 How to program an instrument using a HOT KEYThe XC1000D uses a standard Dixell HOT KEY (cod. DK00000100).4.2.1 How to program the HOT KEY.1. Program one controller with the front keypad.2. When the controller is ON, insert the “Hot key”. Enter the SERVICE menu and push the UPLkey. The display will shows the message “PLEASE WAIT”.3. The instrument will shows during 10sec:“END”: the programming phase is ended successfullythe “ERROR” message is displayed for failed programming. In this case push again the UPLkey if you want to restart the upload again.4.2.2 How to program an instument using a HOT KEY1. Switch off the controller or enter the SERVICE menu.2. Insert a programmed “Hot Key” into the 5 PIN receptacle3. Turn the controller on, or push the DOL key of the SERVICE menu.4. Automatically the parameter list of the “Hot Key” is downloaded into the Controller memory,the “doL” message is blinking. The display will shows the message “PLEASE WAIT”.4. The instrument will shows during 10sec:“END”: the programming phase is ended successfully.Remove the “Hot Key”, the XC1000D will restart working with the new parameters.NOTE: until the “Hot Key” is inserted, the instrument doesn’t start the regulation.the “ERROR” message is displayed for failed programming. In this case push again the UPLkey if you want to restart the upload again.After 10 seconds the instrument will restart workingwith the new parameters.4.3 How to see the values of analog outputsProcedure:1. Enter the SERVICE menu2. Select ANALOG OUTPUTS sub-menu3. Push the SET key.The ANALOG OUTPUTS sub-menu displays the status of the analog outputs of the controller, withthe following layout:1592021021 XC1008-1011-1015D GB A5 r.1.5A 12.10.2009 XC1008-1011-1015D 16/66