OpenVMS Cluster Systems - OpenVMS Systems - HP

The OpenVMS Cluster Operating Environment
4.5 Configuring and Starting a Satellite Booting Service
$ ! LAN$DEFINE.COM - LAN MOP Client Setup
$ !
$ ! This file was generated by LAN$POPULATE.COM at 8-DEC-1996 14:28:43.31
$ ! on node BIGBOX.
$ !
$ SET NOON
$ WRITE SYS$OUTPUT "Setting up MOP DLL clients in LANCP...
$ MCR LANCP
SET NODE SLIDER
/ADDRESS=08-00-2B-12-D8-72/ROOT=BIGBOX$DKB0:/BOOT_TYP
E=VAX_satellite/FILE=NISCS_LOAD.EXE
DEFINE NODE SLIDER
/ADDRESS=08-00-2B-12-D8-72/ROOT=BIGBOX$DKB0:/BOOT_TYP
E=VAX_satellite/FILE=NISCS_LOAD.EXE
EXIT
$ !
$ WRITE SYS$OUTPUT "DECnet Phase V to LAN MOPDLL client migration complete!"
$ EXIT
6. Run LAN$DECNET_MOP_CLEANUP.COM.
You can use LAN$DECNET_MOP_CLEANUP.COM to remove the clients’
MOP downline loading information from the DECnet database. Compaq
recommends that you review LAN$DECNET_MOP_CLEANUP.COM and
remove any obsolete entries before executing it.
The following example shows a LAN$DECNET_MOP_CLEANUP.COM
command procedure that was generated by LAN$POPULATE for migration
from DECnet–Plus to LANCP.
Note: When migrating from DECnet–Plus, additional cleanup is necessary.
You must edit your NCL scripts (*.NCL) manually.
$ ! LAN$DECNET_MOP_CLEANUP.COM - DECnet MOP Client Cleanup
$ !
$ ! This file was generated by LAN$POPULATE.COM at 8-DEC-1995 14:28:43.47
$ ! on node BIGBOX.
$ !
$ SET NOON
$ WRITE SYS$OUTPUT "Removing MOP DLL clients from DECnet database..."
$ MCR NCL
DELETE NODE 0 MOP CLIENT SLIDER
EXIT
$ !
$ WRITE SYS$OUTPUT "DECnet Phase V MOPDLL client cleanup complete!"
$ EXIT
7. Start LANCP.
To start LANCP, execute the startup command procedure as follows:
$ @SYS$STARTUP:LAN$STARTUP
%RUN-S-PROC_ID, identification of created process is 2920009B
$
You should start up LANCP for all boot nodes as part of your system startup
procedure. To do this, include the following line in your site-specific startup
file (SYS$MANAGER:SYSTARTUP_VMS.COM):
$ @SYS$STARTUP:LAN$STARTUP
If you have defined logicals for either LAN$DEVICE_DATABASE or
LAN$NODE_DATABASE, be sure that these are defined in your startup
files prior to starting up LANCP.
4–12 The OpenVMS Cluster Operating Environment