DigiVIT User Manual - Kaman Precision | Position sensors

APPENDIX C: digiVIT TYPICAL SPECIFICATIONSSpecifications below are typical but are sensor and target dependent. Some magnetic targetsmay not work well with the digiVIT.Parameter Specification NotesPower Supply +18-28V Current will change with inputInput Current 0.13A At +24V input typicalVoltage Output 0-5V,+/-5V,0-10V,+/-10VVoltage and current are simultaneouslyoutput, Outputs will over/under range by 1%Current OutputRangeOffsetResolution0-20mA, 4-20mA33% of sensor diameterstandard10% of range1/3000 RMS at fullbandwidth no filteringRanges can vary typically from 5% of thestandard range to 150% of standard rangeon non-magnetic targets. Magnetic targetsare highly variable.TypicalResolution Static 1/100000 RMS TypicalLinearity 6 pt. Cal 0.3% of Full Range Least Squares over standard range typicalLinearity 21 pt. Cal 0.1% of Full Range Least Squares over standard range typicalTargetsTemp Co w/o temp compAny conductive0.1%FR/ o CSome magnetic targets may not work well oronly over a substantially reduced rangeStandard range/AL target Typical sensorhead only -- no cableTempCo w/Temp comp 0.02%FR/ o C Standard range/AL targetElectronics TempCoElectronics Temp Range0.05-0.1%/ o C0-50 o CStandard range/AL target TypicalW/Electronics Temp Comp 5x typicalimprovementSensor DC Resistance 0.5 to 20 ohms 20 is 'no sensor'Sensor Inductance10uH to 50uHIt has been tested with sensors in this range.It may work with sensors up to 10mH inspecial situations not guaranteed.Specifications Subject to Change without Noticewww.kamansensors.com PART NO: 860525-001Last Revised 9/16/2013- 26 -