Myson Lo-Line Fan Convector Installation Guide.pdf - BHL.co.uk

More documents

Recommendations

Info

LO-LINE RC & LO-LINE RC Heater Cooler0911.0 Operating InstructionsDescriptionThis LO-LINE unit is fitted with a control system that provideseither automatic or manual control of the unit. In automaticmode the desired temperature set point is selected and the unitwill adjust the fan speed according to the difference betweenthe actual room temperature and the set point. When the roomtemperature reaches the set point the fan will switch off andthereafter will continue to cycle on and off to maintain the roomtemperature. The temperature set point range is 15 - 35°C.In manual mode any of the three fan speeds can be selected byoverriding the automatic temperature control. This means thatair circulation can be provided in summer for example, or thatheating performance can be controlled manually.The unit can be controlled using the infra red remote controlhandset supplied with the unit (see fig.5) and also using thecontrol panel on the unit (see fig. 6). If necessary, however, thecontrol panel can be locked electronically to prevent tamperingonce the controls have been set (see below).Fig. 5 Fig. 6The remote control hand set takes 2 AAA batteries (not supplied).ControlsDisplayHeatingPower button Switches unit on & off‘+/-’ button Adjust temperature set point from15 - 35°CScrolls into F1, F2 or F3 manual modeHeating will only be provided when the central heatingboiler is on, the pump is running and the system watertemperature is greater than 43°C. Ensure the boiler is on,and set timer, boiler controls and room thermostats asnecessary.11.010.0
10 LO-LINE RC & LO-LINE RC Heater Cooler11.0 Operating Instructions (continued...)OperationPower offDisplayNo DisplayManualManual mode can be used for air circulation without heat.Switch on supply to unit(unit off)for 30 secondsUse ‘+’ to scrollbeyond 35°COr use ‘-’ to scrollbelow 15°CSelected fan speeddisplayedSupply on / unit offSwitch on unitSet point flashes for5 secs, thenAmbient temperaturedisplayedScrolling back out of manual using the ‘+’ or ‘–’ button will revertthe unit back to last temperature set point.Use ‘+/-’ to adjustset pointSet point flashes for5 secs, thenAmbient temperatureCooling Mode● Close the heating system and isolate any other heat emitters.● Open the cooling water system.● Ensure cooling is on, and set cooling unit timer and controlsas necessary.Cooling operation works in exactly the same way as heating.Follow the procedure above to set the unit controls.The ambient temperature is always displayed unless the watertemperature falls below 43°C*, or if the set point is beingadjusted.Water temp
Page 1 and 2: MYSON Eastern Avenue, Team Valley,
Page 3 and 4: Contents1.0 General Information 032
Page 5 and 6: 04 LO-LINE RC & LO-LINE RC Heater C
Page 7 and 8: 06 LO-LINE RC & LO-LINE RC Heater C
Page 9: 08 LO-LINE RC & LO-LINE RC Heater C

Myson Lo-Line Fan Convector Installation Guide.pdf - BHL.co.uk

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?