Manufacturing Readiness Level (MRL) Deskbook

More documents

Recommendations

Info

for Milestone C will decide if the program will enter LRIP or FRP.LRIP is 8 while the target is 9 for FRP.The target <strong>MRL</strong> forIf LRIP is required, to the extent practical, this production effort should beperformed in a manner that uses designs, tooling, materials, components, facilities, andpersonnel that are representative of the FRP environment. The FRP decision requiresthat manufacturing risk is understood and that the manufacturing processes for thesystem be capable, in control, and affordable. Prior to the FRP decision, amanufacturing readiness assessment should be conducted to ensure any outstandingrisks will not impact the programs ability to deliver FRP requirements.Assessments of manufacturing readiness may be used to capture manufacturingproduct documentation. It is a best practice to incorporate the preservation of suchmanufacturing product technical data packages in the Data Management Strategy.3-11
This page is intentionally left blank.3-12
Page 1 and 2: Manufacturing ReadinessLevel (MRL)
Page 3 and 4: CONTENTS1. Introduction ...........
Page 5: APPENDICESA. Detailed MRL Definitio
Page 8 and 9: This page is intentionally left bla
Page 10 and 11: contract, modern technology, produc
Page 12 and 13: considerations is needed to ensure
Page 14 and 15: • Are materials and tooling avail
Page 16 and 17: circumstances a program is facing,
Page 18 and 19: 2. Manufacturing Readiness Levels2.
Page 20 and 21: This level of readiness acts as an
Page 22 and 23: At this level, the system, componen
Page 24 and 25: the maximum extent practical, the p
Page 26 and 27: • Manufacturing Management: Requi
Page 28 and 29: 3. MRLs and the Acquisition Managem
Page 30 and 31: matures so that manufacturing matur
Page 32 and 33: Other important outputs of the asse
Page 34 and 35: If any risk areas are found to fall
Page 36 and 37: During EMD, assessments of manufact
Page 40 and 41: 4. The Process for Conducting Asses
Page 42 and 43: one would not expect the same manuf
Page 44 and 45: should be assessed on-site and othe
Page 46 and 47: It is also important for the progra
Page 48 and 49: 4. Contractor overview and discussi
Page 50 and 51: Finally, the assessment team should
Page 52 and 53: The report may also provide informa
Page 54 and 55: • Understanding of the potential
Page 56 and 57: o Prevent the adoption of a technol
Page 58 and 59: program element will be achieved by
Page 60 and 61: perform or support these assessment
Page 64 and 65: Table A-1. Manufacturing Readiness
Page 74 and 75: Table A-6 Manufacturing Readiness L
Page 80 and 81: IMSITRJDMTPKCLRIPMDAMMPMRLMSMSANASA

Manufacturing Readiness Level (MRL) Deskbook

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?