Profile cylinders Euromec, Series 168 - Bosch Rexroth

Base plate for direct mounting of ISO valvesPiston Ø Part no. ValvesizePort nos.1, 2, 4, 3,(5)Port nos.12, 14A B C D E F G H K Weight[kg](lbs)32-125 5801690000 ISO 1 G 1/8 G 1/8 93,5 80 62 35 8 9 20 15 40 0,175(0.386)63,125 5802690000 ISO 2 G 3/8 G 1/8 127 109,5 81,5 46,5 11,5 13 32 29 60 0,580(1.28)Installation InstructionsConnection: Outlet port 2 of the valve should be connected to the end cover where the base plate is fitted.Outlet port 4 is connected to the opposite end cover with tubing.Exhaust ports 3 and 5 are combined in the plate to a common exhaust port.Inlet port 1 and control ports 12 and 14 are located on one side of the plate.Flow: The maximum flow for a valve mounted on these base plates is somewhat lower than for a valve mounted on the subbase.Installation: The plate is fitted directly on the front or rear end cover of the cylinder with a banjo thread. G 1/2 is required.Alternatively one or the other of the two banjo threads (G 1/8 and G 1/4) supplied for base plate 580-169 can be used, depending on the size ofthe cylinder port.A size G 3/8 banjo thread is supplied for base plate 580-269. For cylinders 100 and 125 mm dia., a reducing nipple for the cylinder connectionport G 1/2 is required with Part no. 8631123800.Min. strokes: The table below shows the smallest stroke which a cylinder can have when the base plate is turned towards the opposite end coverand connected with fittings and plastic tubing 6 mm dia. for 580-169 and 12 mm dia. for 580-269.Minimum strokes [mm]Piston Ø Stroke Valve32 50 ISO 140 50 ISO 150 50 ISO 163 100 ISO 1, ISO 280 100 ISO 1, ISO 2100 100 ISO 1, ISO 2125 100 ISO 1, ISO 21